Antonio M December 24, 2020 for Model Number FFLE1011MW2 My washer starts, fills with water, then agitates the clothes. After that it does nothing. It’s almost like it’s off but the lid is still locked. Then after what would normally be the spin cycle it starts up and drains. The tub is completely drained but because it doesn’t spin they are still very wet. I’m thinking it’s the control board? Is there anything else it could be?
1 Answer Antonio, Inside the unit there will be a tech sheet. It would be recommended to put the unit into a service diagnostic mode and see if there are any stored error codes. This will guide you to what is wrong with the unit. It could be a pressure switch that is not resetting to empty not allowing the unit to spin, could be a control board that is at fault. Read More...
Juan May 13, 2017 for Model Number FFLE1011MW1 This machine is getting stuck on a wash cycle, it will continuously wash and wont advance to continue its cycle.
1 Answer Juan, This issue would most likely be caused by a faulty main control board part number A00537602. Read More...
Angel March 17, 2017 for Model Number FFLE1011MW0 I started having problems with my washer after a power cut. The technician checked and said to replace the main control board (137469113), I bought it and installed. But the fault continued. The technician then said it was the user interface board (137332702), I bought it and installed it but the problem continues. The washer does not work, no beeps. The last thing was the replacement of the wiring, but it was unsuccessful. Still not working and according to the technician the main control board is throwing an E91 error. Both control boards are new. Line voltage is 119V and 208V. I would appreciate your valuable help. Thank you.
1 Answer Angel, This model is not showing a E91 error but with all other errors in the 90s this would be considered a communication issue. It would be recommended to try a different main control board as they do sometimes come in defective. Read More...
Phillip March 01, 2016 for Model Number FFLE3911QWO Machine washes very weak when there is lots of water in the machine and cloth sometime still have detergent on them. Machine keeps spinning after wash and will not go into the rinse cycle. it would slow down as if it is stopping but then it would pick up speed and you can hear the pump kick in but, still it will not go into the rinse cycle.
1 Answer Phillip, With the symptoms the unit is having it sounds like the issue will be a faulty control board. Read More...
David C July 17, 2014 for Model Number ffle1011mw1 As the machine is washing it keeps cutting off during washing.
1 Answer David, You will want to check the wiring for the unit to make sure that there are no loose or bad connection. If this checks ok then the most likely cause for the issue would be a faulty control board. Read More...