Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Control - Temperature by Frigidaire

Best Seller
Manufacturer Part
4.89 (64)
By: Frigidaire
Part Number: OEM6340344
Manufacturer Part Number: 216521100

Questions & Answers

For Frigidaire Control - Temperature (Part Number: OEM6340344)

1 Answer

Larry, unfortunately, as the manufacturer has discontinued the temperature control thermostat 216521100 and has not provided an approved substitute, one could not be recommended due to likely operational differences.

Read More...

1 Answer

Dennis,

Based on all the information, this issue does sound like it would be caused by a issue with the temperature control which is part number 216521100.

Read More...
Joe S for Model Number Frigidaire AFFU2068DWO

I am getting a nuisance temp alarm. It seems to happen almost every twelve hours but can happen in the middle of the night . I walk down only to find freezer is working fine and food is frozen. I hit the temp reset switch and alarm silences. I noticed top of front door gasket does not seem to seat as well as other sides of gasket and noticed some icicles( 4 -6 inches) in top of freezer. Is the temp switch the problem or could this gasket be a contributor. This is a frost free freezer. Also where is the temp switch located? Thank you kindly

1 Answer

Hello Joe. It sounds like the board 216833800 is bad. The problem is the board needed has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part.

Read More...

1 Answer

Hello Clay. Based on the information you provided, it sounds like the temp control is bad and will need to be replaced on the unit.

Read More...

1 Answer

Hello Wes,

The thermostats 216521100, or as the manufacturer likes to call it, the cold controls, on these units are a common failure, so replacing it is a very good idea.

Read More...

1 Answer

Hello Randy. Is there frost build up on the back freezer wall? If so, there is a defrost problem. If there is no frost build up, you will need to check and see if the compressor is running. If not, you will need to test the compressor. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. Hope this helps. http://forum.appliancepartspros.com/refrigerator-freezer-repair/193358-freezer-fridge-not-cooling.html

Read More...

1 Answer

Hello George! A sealed system repair consists of the replacement of one of the following parts; compressor, evaporator, condenser, interconnecting tubing, drier and/or refrigeration charge. Thanks!

Read More...

1 Answer

Hello Bob. If the unit is shutting off, before the temperature is reached, then the temperature control 216521100 could be bad. If it continues to run, but does not get cold enough to freeze, you will need to remove the back wall inside the freezer and see if there is an ice ball on the evaporator coils 216195900. If so, there could be a restriction in the sealed system. If it is clear, you will need to feel the filter dryer 5303305677 and see if it is warm. If not, you may have a restriction or a freon leak. If either one of these are bad, you will need a sealed system repair. Hope this helps.

Read More...
Dmw for Model Number MFU20F3GW5

My Frigidaire seems to run all the time but sometimes it runs 10 degrees F and sometimes it is above 32 degrees F. It is unpredictable. As far as I can tell, even when the temp is above 32 degrees, there is no ice build up in the back wall, the air flows normal. Any ideas what is wrong with my freezer? I plan to buy a temperature control and replace it with AP2113445 but I don't know if that will fix it--it seems to run all the time. Any help or suggestions would be appreciated.

1 Answer

Hello DMW. The temperature control 216521100 would be the first place to start. If it is bad, it can give false temperature readings. Also you will need to feel of the filter drier 5303305677 located on the back of the freezer. If it is cold, you may have a restriction, which is a sealed system repair. Hope this helps.

Read More...

1 Answer

Hello Richard. Inside the freezer on the back wall, do you see any frost build up? If so, you may have a defrost problem. Also check the door gasket and make sure it is sealing properly. Hope this helps.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google