Tim February 26, 2022 for Model Number FPES3085KFG Frigidaire Range I'll be replacing the Oven Controller 316560143 / AP4451899. I'm trying to figure out how to remove the control panel to get access to the oven control board. I can't find any videos for this specific model. Any suggestions? Thanks
1 Answer Hello Tim, You will need to pull the knobs off and remove the nuts under the knobs. This will allow the panel to lift off exposing the screws to access the controls. Read More...
William October 25, 2019 for Model Number FPES3085KFG top right hand large stove top burner will come on and stay on even with knob turned off.
1 Answer William, the failure is going to be in the relay control board 316442119 not opening the relay for the burner. With the power cord disconnected from the wall outlet, the relay board would be tested from connection J1 pin 3 (red wire) to terminal P12 for continuity. If there is continuity at this point, then the relay board has failed with the relay stuck closed. If there is not continuity, then the likely failure is in the burner control 318411401. Read More...
Sandi November 26, 2018 for Model Number FPES3085KFB When I press the start button, it does not beep and does not start the oven, every other button works. Do I need to replace part #20 the controller?
1 Answer Sandi, With only the start button not working this would most likely be a faulty control panel which is part number 318922144. Read More...
Davidd October 21, 2018 for Model Number FPES3085KFA All of the burners on my range stopped working. There are no Error messages. There are no responses when I turn the burner knobs. The oven and the warming drawer and pad work. I tried to get it to work by replacing the relay board in the back of the range. (part number 316442119) but that did not solve the problem. (By the way, I replaced the panel assembly part number 318922144 in August of 2015 when the range had previous problems.) What do I need to do to fix this?
1 Answer Davidd, For this issue the most likely cause of failure would be the user interface board part number 316442062. Read More...
Brian J November 20, 2016 for Model Number FPES3085KFC When I turn on Bake 350* the broiler comes on and stays on. I think that the control board is messing up but im not possitive. Please help!!
1 Answer Brian, The broil element should come on but only during the preheat process and will be on partial power for browning purposes during the bake. If it is staying on glowing then it would be an issue with the control board. Read More...
Tim May 31, 2016 for Model Number FPCS3085LFA Hi I Got the EO-95 code and replaced the induction board and filter in the same housing and then got a EO-21. Found a lose plug between the two boards and fixed. Now I have a EO-39. Configuration Conflict. Can the unit be reconfigured? Or will the interface need replacing? The Warm/R/F burner-beep is for the new controller. This one has knobs. the new controller has the buttons to make this work Thanks Tim
1 Answer Hello Tim. Try resetting the unit. If it continues, then replace the interface. Read More...