Rj Daniel February 13, 2014 for Model Number FGEF3032KBB The element will not heat up. The surface is cold however the surface hot light is on. What can I do? Is this a danger, should I unplug the range.
1 Answer RJ Daniel, The hot surface indicator staying on would not be a danger if the element is not coming on. Most likely with the issue that you are having the problem would be in the switch. Check with the switch in the off position for power from P to ground on the switch. If there is power then the switch is faulty and would need to be replaced. If there is no power then the element is bad and would need to be replaced. Read More...
Peter S February 02, 2013 for Model Number LGEF304DKFA My left surface element stopped working. I ordered and replaced that part (see order # 3058605). The old element had clear signs of damage at the point where the wiring is attached, burnt. New element did not work. Then replaced the Control Assembly (see order #3083507). That did not work. Called a Frigidaire approved tech at that point. Reviewed all items that had been replaced. Concluded that it then must be the power board (see order# 3094483). Replaced power board. That did not work. I then moved the wiring from the left non functioning burner to the right burner. Using now the left control knob, the right burner works, so power is moving properly through the control knob to the left burner. I moved the wiring from the right working element to the non working left element. Left element still did not work. Concluded the replacement element must be defective. You sent me another element. It does not work. Once again I took the left element wiring and moved it to the right element. Turns on immediately. Moved wiring from right element to non working left element. Nothing......
1 Answer Hello Peter, You will need to do a voltage test on at the element to make sure that you are getting power to the element and that you are not loosing power from loose or broken wire. If you have power then it is a bad element. Read More...