Jennifer September 10, 2011 for Model Number 41744092500 how do I get the knob off to get this old part off(1334443100)
1 Answer Jennifer, Its a bit more involved, Heres some help : 1. Disconnect the washer from the electrical supply, remove the top panel and etergent drawer. 2. Removethe(2)screws,one on each end,holding the console to the top of the side panels. 3. Remove the(3) screwsbehind the detergent drawer panel. 4. Lift the(3) tabs to releasethe top of console from the mounting plate. 5. Roll the console forward, while lifting up to release the bottom tabs from the front panel. 6. Unplug the wiring harness from the control panel andlift the panel off. Laythe console on a soft flat surface, remove the (5) screws holding the control to the console. Lift the control out of the console.1. Disconnect the washer from the electrical supply and remove the electronic control. 2. With the electronic control removed the delay start button will lift out. With the electronic control removed the interface board will lift out. Usinga pair of pliers squeeze the knob shaft and pull the knob out the front of the control panel. Thanks and Good Luck Read More...