Bonnie February 11, 2020 for Model Number 587.14432200 kenmore 18" It seems my spray arm is not working because there is no water on the dishes lower or upper racks, and the d/w is not draining. It will run through all the cycles but does not clean the dishes or drain the water out. It is an 18" d/w built-in. We ordered the seal, it is not the same as the original has a round top, not a square top that fits the impeller on top. help!!
1 Answer Bonnie, The seal kit for your dishwasher would be part number 134115600. For the issue of the pump not circulating the water or draining you will want to check to make sure that there is power getting to the pump motor. If there is but the pump is not circulating then the motor is faulty and would need to be replaced. Read More...
Tricia September 24, 2016 for Model Number FDR252RBS1 My dishwasher isn't draining. I was told it needs a pump but what pump exactly.
1 Answer Tricia, The pump on this unit would be the wash/drain pump which if the dishwasher is just not draining then this would be more likely a issue with the drain impeller being bad or the wash motor 5304459468. Read More...
Colin September 13, 2013 for Model Number fdr252rbb2 How do you remove part number 12 (motor seal) from the motor shaft?
1 Answer Colin, To remove the motor seal from the shaft you would just move it around while pulling up on it to remove it. Read More...