Pedro Monge February 26, 2023 for Model Number FFLG4033QT1 I press the washer start bottom and beeps once and locks the lid, immediately the draining pump star to work but there is no water in the washer after a while it stops. after 3-5 minutes start to do the same but at the end the washer do not start. Dryer is working fine
1 Answer Pedro, Check the pressure hose to make sure that it is not clogged and if it is not then pressure sensor 5304504885 will be the most likely cause for this issue. Read More...
Lauren November 17, 2018 for Model Number FFLE4033QWO Washer stuck in agitate mode, it also takes about 3 seconds to turn off by holding in start button again. Once machine is off it will start again just by turning the washer selector to another wash selection.
1 Answer Lauren, For this issue the most likely cause will be a faulty control board which is part number 5304500454. Read More...
Mike October 31, 2017 for Model Number FFLE2022MW First of there is no number after the MW. Dryer works fine. Washer beeps once and locks the lid, then does nothing for about 15 minutes and then cycles through draining and shuts off. No water, no agitation. 3 beeps when you push start. 1 beep if you push start again, then it locks the lid, and does nothing. Where do i start?
1 Answer Mike, With the unit not filling, double check to make sure that the water is turned on, make sure that the screens for the water valve are not clogged and check to make sure that the water valve is getting power to it. The valve would be the most likely cause if there is power to it but not letting water in if the unit has the water turned on. Read More...
William July 02, 2017 for Model Number FFLE2022MW2 Washer wont do anything but dryer still works. No beep or anything from washer.
1 Answer Hello William. It sounds like the board 5304500454 is bad and will need to be replaced on the unit. Read More...
Victor February 29, 2016 for Model Number ffle2022mwo This washer gets water starts washing then stops and opens the lid switch and stops drains the water, spins slow but wont finish load. What can it be?
1 Answer Hello Victor. Based on the information you provided, it sounds like the control board 5304500454 is bad and will need to be replaced on the unit. Read More...