Bobby May 18, 2016 for Model Number WBSE2090A2WW Unit shuts off during cycle then starts back up seems to take longer on cycles.
1 Answer Hello Bobby. Check and see if the motor is getting hot and shutting down. If not, then it sounds like the control board may be bad on the unit. Read More...
1 Answer Hello Frank. The model number you provided is not working. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Larry Johnson July 15, 2013 for Model Number WBSE3120B1WW My assembly does not have the small board and two dials shown on the right side of your picture. Otherwise the part looks the same. If you give me an address I can send a couple of jpegs. Your part # is WH12X10225 (AP3422790) Your checker says it is compatible with my model.
John December 07, 2012 for Model Number WCSE4160B1WW I replaced the control board. Now when I plug the machine in, all of the LED's across the top just flash, and I can do nothing else. What do I need to do now? Thank you,
1 Answer Hello John. You will need to check and make sure all the connections on the unit are good and tight. If so, try pluggin in the unit and selecting the cycles and see if the unit works properly then. Read More...
Darrell P. September 03, 2011 for Model Number AP3422790 Is this a difficult part to be replaced by a novice? My washer seems stuck in the final spin cycle, is there anything I can check for?
1 Answer Hello Darrell. The control assembly WH12X10225 is not hard to replace. Check and make sure the drain pump is not clogged and the water is drain out of the machine properly. Hope this helps. Read More...