Gary September 20, 2016 for Model Number WPDH8800J1WW My GE Profile washer is sometimes stopping before a wash cycle completes. The display is illuminated with the correct setting is just stops as if the pause button were pressed. It also stopped sending information to the GE profile Dryer via the connection wire telling it what wash cycle was completed. I ran a service mode test and found an E20 error (Overload Current).
1 Answer Gary, The causes for the E20 error would be something lodged between the inner and outer baskets. There is a possibility that the bearings are seized check the condition and mounting of the the door gasket, replace or remount as needed. Ensure inner basket rotates freely. If all this checks ok then you will need to replace the drive motor. For the communication between the 2 units it will not communicate with the unit getting this error code. Read More...
Kenny S. March 02, 2013 for Model Number wpdh8800-jzww If you replaced the control board, should your cycles change from color and whites and should you be able to change the soil and temperature controls?
1 Answer Hello Kenny, This sounds like either the control WH12X10593 is defective or it is not the correct one for the model you are installing it in. Read More...