Customer Questions and Answers for Conversion Kit by Ge

Hello Al, LP conversion kit WB28K10555, is correct for your model, the oven burners have adjustable orifice hoods, and need not be replaced, to adjust: 3. Using a ½” wrench, tighten the orifice hood(s) supplying gas to the oven burner(s) clockwise until snug. 4. Open the air shutter on the oven burner(s) to the full open position and adjust as needed.

Brooke, The conversion kit is part number WB28K10555. You will need to convert the pressure regulator also by removing the cap and flipping the plunger also.

Jeff, You would need to get 4 orifice spuds WB28K10023 for the main top and for the oven you would tighten the orifices to snug, make sure that the air shutters on the burners are 3/4 of the way open and flip the brass cap on the regulator.

Hello Greg, the manufacturer list part number WB28K10555 as the correct conversion kit for your unit. Thanks!

Penny The parts you need are WB28K10191, WB28K10188, WB28K10192, WB28K10190 and replace one at a time so no confusion as to what goes where. I sent you instructions but for converting lp to natural so just reverse the instructions.

Ed, The part number for the conversion kit on this unit will be 318565400.

Jim, The part number for the .89 orifice will be WB28K10023.

Hello Terry, You will need to order WB28K10188 for the left rear, WB28K10191 for the right rear, WB28K10190 for the left front, and WB28K10192 for the right front. Be aware that this is the only way to get the orifices, (with the tubes). The tubes do not need to be replaced unless there is damage to the old ones. The orifices can be removed from these tubes and installed in the correct positions as per the description of the parts, (LF, LR, RF, RR). The orifices are not the same so care should be taken to properly position them on the cooktop to prevent a hazard.

Hello Martha, You will need to order two WB28K10023 for the left front and rear surface burners, one WB28K10834 for the right rear surface burner, and one WB28K10032 for the right front surface burner. You will then need to convert the regulator by removing the large nut under the plastic cap and flipping it over. You will also need to turn the bake and broil hoods clockwise 1 1/2 to 2 truns or until tight without overtightening.

Hello Maria, you'll need the following orifices to convert your cooktop burners. The burners on the left front and left rear use part number WB28K10023, for the right front you'll use WB28K10032 and for the right rear you'll use WB28K10834. The oven gas valve and regulator are convertible, please refer to your use and care guide for conversion instructions. Thanks!