Kevin C. January 11, 2020 for Model Number JGBP90MEHIBC WHEN I HOLD UP THE NEW CONTROL BOARD TO THE EXISTING BOARD THEY DON'T APPEAR TO MATCH. I THINK MY PART NUMBER IS #PS953678, YOU SENT WB27K10147.
1 Answer Hello Kevin, the manufacturer is offering a suitable replacement to take place of the original board. The part you received should be compatible with the model number you've provided. Read More...
Cherie May 15, 2018 for Model Number JGBP85BEH1BB I'm getting a code 71D7 flashing for no reason on my GE gas stove. I think that was the code. It starts beeping and that flashed across it then disappeared. It's done it twice when I was in another room and not using it. What part do I need to replace?
1 Answer Cherie, The 71D7 would be the code for the control board and if it is continuing to do this then it would be a faulty main control board on the unit. Read More...
Bob November 16, 2017 for Model Number jgbp85weh1ww The touch screen on my ge mod #jgbp85weh1ww gas oven seams fine but the # do not register #3 5 7 0 when you press the key pad
1 Answer Hello Bob. You will need to order and replace the touch pad WB27K10117 on the unit. Thank you. Read More...
Glenn P. January 02, 2016 for Model Number JGBP85WEJ1WW There was a power surge and my oven and control panel do not work. The gas turns on. If I replace the control panel, will it work? The part number I found is WB27K10147.
1 Answer Hello Glenn, You should test for 120Vac from terminal L1 to terminal N. If present, replace the control WB27K10147. If not, you will need to trace the circuit back to the power supply to see where the voltage is being dropped. Read More...
Scott May 23, 2014 for Model Number JGBP90MEH1BC hello, serial number is ZF270300P. I am getting F7 E8 error on my GE oven. from my research I found out that if I switch below part, then the problem would go away http://www.appliancepartspros.com/ge-erc3b-control-wb27k10147-ap3792953.html however, after replacing the part I am still having the same error. Your customer support stated that the part I really need to replace is: http://www.appliancepartspros.com/ge-membrane-asm-wb27k10135-ap3792951.html Customer support said I should check with a technician to make sure before ordering 2nd part. Can you please assist and confirm what part I need to fix this problem?? thank you
1 Answer Scott, The F7 is a shorted matrix key. Disconnect the membrane from the control. Power down then power up the range. If the fault condition does not return in 15 minutes it indicates a faulty membrane and would need to replace the membrane switch WB27K10135 IF the fault returns within 15 minutes then the control board is defective. Read More...
Barbara M. October 30, 2012 for Model Number JGB920SEF SS The Control Board (touch screen) on my GE Range, Model JGB920SEF SS, was compromised / melted by steam escaping from a large pot whose lid was too close to the Touch Screen. What Part Number best fits this model for replacement? What is the difference between WB27K10145 and WB27K10147? Thank you.
1 Answer Barbara, the electronic board WB27K10147 (WB27K10147) has buttons on the board itself and the electronic board WB27K10145 (WB27K10145) is a glass touch, no buttons on the board. Your model uses part number WB27K10145. The control panel and overlay is part number WB36K10588, if needed. Thanks! Read More...