John September 08, 2021 for Model Number PDWT480P00SS GE Dishwasher - Model PDWT480P00SS I had problems similar to the others listed under the Control Panel - constant cycling. I replaced the Control Panel and the dishwasher ran through the start-up test cycle. I was then able to press reset and the dishwasher drained. Now, however, there is no response to the keypad and nothing happens at all. The door does beep when I close it so I know there is power. Please advise - thank you.
1 Answer John, it would be recommended that the wire connections are inspected for any indications of corrosion, loose connections, or pinched/broken wires. If these check good, it is likely that the control module WD21X10363 is bad. Read More...
John September 08, 2021 for Model Number GEW9200LW0 I had problems similar to the others listed under the Control Panel - constant cycling. I replaced the Control Panel and the dishwasher ran through the start-up test cycle. I was then able to press reset and the dishwasher drained. Now, however, there is no response to the keypad and nothing happens at all. The door does beep when I close it so I know there is power. Please advise - thank you.
1 Answer John, unfortunately, the model number provided appears to be an invalid dishwasher model. If the model number of your appliance could be verified and provided in a new question, this may allow for the most accurate information to be presented. Read More...
Tom January 18, 2019 for Model Number PDWT480P00SS I recently replaced the control module and now the panel doesn't respond. "Cookware", "heated dry", and "sanitized" lights are on, while "temp boost" light flashes. I am unable to alter these lights. With door closed, I can start washer by pressing "start". Is there any way to reset the control panel? Thank you
1 Answer Hello Tom, It sounds like there is an issue with the keypad WD34X11469. If this doesn't correct the issue you will need to replace the new control module since it is the only other thing that can cause this issue. Read More...
John June 13, 2018 for Model Number PDWT580P00SS This GE profile dishwasher was put in service in 2009, it gets used approximately once a week. Now when it starts a wash cycle, and this goes for any cycle it's set on, I can hear it fill and start to wash, 5-10 mins later it starts to drain, then regardless of cycle it was set on will go right back to starting a wash cycle... where it fills, washes some, then drains, and restarts again. When it does this it will reset to a default wash cycle. For example if it was set for a quick 50min rinse when it resets it will go back to a 110min cycle I have tried multiple settings on the keypad, all with the same result. I have since attempted to reset it by turning the breaker off for 10mins and starting again, with no change in function. The control panel and all other functions appear to operate as normal.
1 Answer John, With the resetting of cycles and the short wash times this issue will most likely be caused by a faulty main control board. Read More...
Jon R January 29, 2017 for Model Number PDWT480P00SS How can I test the WD21X10363 control module if the control panel is not working. I have power thru the door switch to the control board. It has work intermittenly on different functions even with no lights on the control panel. There was some corrosin around the first two pins on the left side of the control panel connector. it has started on its own several times in the past. At that time there were lights on the control panel.
1 Answer Jon, Unfortunately there is not a way to test the control panel of the unit and this issue sounds like it will be a faulty control panel since the unit will work sometimes with no lights on at all. The part you will want to replaced will be the keypad WD34X11469. Read More...