Rebecca June 25, 2020 for Model Number JGS968SH3SS I need the wiring harness behind the control clock and am not seeing that part anywhere on your site. If you order a new control clock, shouldn't you be getting the wiring with it as well? Please advise....
1 Answer Rebecca, unfortunately, the manufacturer does not list the wire harness due to it not being available. Read More...
L & T August 04, 2017 for Model Number JGS968SH3SS My oven stopped preheating. after the appliance guy changed out an igniter. The oven temperature was not reaching the correct programed temp. (oven set at 250 only reached 200 according to the temp meter the repair person had). Also the convection fan wasn't turning on when the convection selection was started. The appliance person said the clock assembly has to be changed. After spending 150.00, I don't know if I should spend another 260.00 for the part plus install at 100.00. The oven is 13 years old. And I was thinking that I could try to adjust the temp. myself using the manuals direction to do that. Could that be the problem? The temp just needs adjusting? Thanks!
1 Answer L & T, Changing the temp on the control will not adjust it in the range of 50 degrees that you are seeing the issue with. You will want to check the oven sensor to make sure that it shows a resistance of 1090 ohms at room temp. If the sensor checks ok then this will likely be the control board that is faulty. Read More...
Dom September 19, 2015 for Model Number JGS968S0H2SS I replaced the WB27T11252 OVEN CONTROL ( CLOCK) but now it displays: Loc rEF. None of the keys work. What's the problem?
1 Answer Dom, You will want to try to push the 9 and 0 buttons for 3 to 5 seconds and see if it will go to normal use. If it does not then it sounds like you may have received a faulty control board. Read More...
John H November 16, 2014 for Model Number WB27T11252 I installed the replacement control and now the clock works, but when I turn on the oven nothing happens. The control shows that it is working, but the oven does not turn on, the fan does not go on, nothing. Is it a cable? or did something get pulled off as I installed the new part?
1 Answer John, To properly assist you we will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Frank January 21, 2013 for Model Number JGS968BOH4BB I REPLACED OVEN CONTROL (CLOCK) I need to know is there a special glue or paste to use to seal the glass top and t the control panel to the range , I have a GE oven range part # wb27t11252 thank you
1 Answer Hello Frank, No there is no special glue or paste for sealing glass top and control panel. Read More...
Sean D. January 25, 2012 for Model Number JGS968SH4ss What is the best way to access the control panel on my oven? I am handy and have replaced many parts on appliances, however, once I removed the screws that I thought where holding the front face ( control panel) in place, it did not want to give. Any help is welcome.
1 Answer Hello Sean. You will need to remove the control panel knobs and the large nuts under the knobs. Once removed, the control panel will lift off and you can replace the oven control WB27T11252. Hope this helps. Read More...