Norman S. August 22, 2015 for Model Number JTP56SD1SS I have a GE JTP56; it stopped working and shows error code F0. Based on research, it seems likely that the Control Panel assembly needs replacing. Before I order this part from you, is it possible to rule out the possibility that the Electronic Range Clock Control kit also needs replacing? That would be another $400 and while it is definitely worth putting $400 into the oven, I am not sure it is worth spending $800. Thank you
1 Answer Hello Norman, You will need to order the control panel WB36T10440 as per the manufacturer. The tech sheet recommends the following: Determine if problem is with Key Panel or Control by disconnecting ribbon cable and measuring flat cable pins 13-14 . Should be open. Should be 100-150 ohms while pressing OFF key. Read More...
Robert October 26, 2013 for Model Number Jtp56sod1ss The keypad is non responsive the only buttons that make noise are the stop/clear buttons for upper and lower oven. When disconnected and reconnect to 208v the oven will start working and keypad also. After a few days again the keypad stops responding. Is it the keypad or control board? Thank you
1 Answer Hello Robert. Check the connections on the keypad. If they are good and clean and dry, replace the control panel WB36T10440 on the unit. Read More...
Cindy September 28, 2011 for Model Number JTP56S0D1ss The oven the beeping and control panel flashing F7, F0, etc. then goes off. I have replaced the electrical piece and this still happens. Is it the control panel? The oven is about 10 years old.
1 Answer Hello Cindy. Based on the information you provided, you will need to replace the touch pad WB36T10440. Hope this helps. Read More...