Customer Questions and Answers for Range Control Panel Assembly by Ge

Steve,
The faceplate assembly is part number WB27T11079 and the main top part number is WB62T10726 Unfortunately the top has been discontinued by the manufacturer & is no longer available.
No alternate or substitute part has been recommended by the manufacturer.

Hello Mike. Sorry, it is only offered as the assembly WB27T10753.

Doug,

Unfortunately this range parts list does not come up and it appears to be this would be a Canadian model which we do not support.

Hello Jay. Removing Faceplate
1. Turn the power off to the unit.
2. Remove all knobs.
3. Unscrew all faceplate retainers while
holding the faceplate against the
control trim. The retainers must only
be hand-tightened.
4. Move the faceplate 3 inches away
from the control panel and unplug the
harness from the panel.
5. Repeat steps in reverse order to
reassemble the unit. The control panel contains the ERC and infinite switches.
To service:
1. Remove faceplate (reference section on control panel assembly).
2. Remove screws (from bottom) securing control panel to vent trim.
3. Remove steel control panel insert by removing 4 screws.
4. Detach from main harness by unplugging the 15-pin and 9-pin connector blocks.
5. Remove 5 screws securing the control panel to the maintop assembly.
6. Control panel can now be removed.

Hi Bob. You will need to order the whole control panel part # WB27T10753. Thank You.

Hello Dan. Remove the knobs and the large nut under the knobs. Then remove the glass control, and then remove the screws holding the control panel in place. Hope this helps.