Joe September 07, 2017 for Model Number DBXR453T5WW The bin is slipping just a little and items are getting caught leaving a dark spot on the clothes
1 Answer Hello Joe. You will need to order and install the bearing kit WE49X20697 into the unit. Thanks. Read More...
Satish May 19, 2015 for Model Number DDG6380VALWH How to remove drum of GE very old dryer having model number - DDG6380VALWH? I want to replace drum bearings as it makes lots of noise. Please help.
1 Answer Satish, Unfortunately we do not have any technical information on this unit. From what it appears, you will need to remove the front panel of the unit by removing 2 screws at the bottom and 2 screws from the door opening at the top. Once this is done you will be able to remove the panel and lift the main top. Once the main top is lifted and front panel is off you will remove the belt. You will then lift the drum and lift it off the back holder for the bearing. Read More...
Bill August 06, 2014 for Model Number dde5300velad The front slides are worn rather badly. Will this cause the dryer to shake, vibrate, and run rough? The metal and felt parts look ok but the slide its self is worn almost to the breaking point
1 Answer Hello Bill, The plastic slide is the important part of the slide assembly. If it is worn as you have described, it should be replaced before you have metal to metal wear take place on the drum assembly WE25X60. This would cause the drum to require replacement also. Read More...
Phil October 02, 2012 for Model Number dde7500galad The dryer blower seems sluggish. I pulled everything apart and cleaned out inside vent. The air pressure seemed good. Seemed a little sluggish when a put back together. Would new glides help it run better for better air flow? Thanks.
1 Answer Hi. Yes the slide kit part # WE25X60 will help the tumbler glide much easier. Is the belt part # WE12X10014 routed properly around the tensioner part # WE12X81 or slipping? Proper4 air flow tells me that the blower wheel part # WE16X16 and the motor part # WE17X10010 are not dragging. If at the back wall your Rear Drum Bearing Kit felt part # WE25M40 is worn out then it will effect the same as the front glides. Thank You. Read More...
Frank April 21, 2012 for Model Number DDE7108VHLWH The picture shows two supports. Are there two (1 pair) per kit assembly? Thank you, Frank