1 Answer Donnie, we can not recommend bypassing the lid switch as it is a safety device. Read More...
Todd September 24, 2019 for Model Number WSM2420D0WW Need to replace lid switch (part 72). What is procedure. Do I need to remove top panel or front panel? How is that done?
1 Answer Todd,You will want to remove the front panel using a putty knife to release a clip on each side of the front panel where it meets the top panel. Usually a couple of inches in from the ends. Once the front panel is removed the lid switch is able to be seen, remove the screws and disconnect the harness and repeat for reassembly. Read More...
Bill September 30, 2013 for Model Number wsm2480d3ww How do you get the front lid off the washer part of this combo washer/dryer
1 Answer Bill, To access the washer you will need to remove the 2 screws securing the safety access transition panel. Remove the panel by tiliting it down and pulling straight out. Removed the 2 screws located behind the washer top and pull the washer top forward to disengage top lock. Disconnect the washer lid switch harness and lift the top off. The lid may want to spring open when handling the top. Read More...
Larry July 10, 2013 for Model Number WSM2420D3WW How to open top of washer to get to lid switch and how to check continuity?
1 Answer Hello Larry. Insert a flat blade into the top corners of the front panel and release the clips and pull the panel toward you and lift off the unit. Now you are inside the unit to test the switch. Read More...