Gwzimmer August 06, 2016 for Model Number GTW2250D0WW The fill cycle does not fill all the way no matter what the setting.
1 Answer GWZimmer, This is an exerpt from your owners manual on page number 6. NOTE: This is a high-efficiency washing machine. This system requires less water while providing effective cleaning action. You may notice that the water level is lower than on your previous washer. This is normal. Read More...
Curt July 27, 2016 for Model Number WDSR2120J5WW This Machine fills & drains but will not agitate or spin, when I set to a cycle it just hums. While draining motor belt & pully on trans turns slowly, after drain is done it just quits. Does this sound like timer problems? would it need to be replaced? Thanks for your time. Curt
1 Answer Curt, You will want to check the lid switch to see if the lid switch is good. If it checks ok then the timer would be the most likely issue for the unit not agitating or spinning. Read More...
Mike November 10, 2013 for Model Number wlsr2200j5ww Is it safe to assume that if my model number is in the cross reference section that this timer will fit my washer?
1 Answer Hello Mike, I would still look the timer WH12X10358 up by the model number since the list can be incorrect. I used the model number you listed to find this number so it will be correct. Read More...
Mark May 12, 2013 for Model Number whdsr209g2ww My Washer completes all cycles flawlessly, except when it gets to the spin cycle, it spins fine but does not want to end. The timer, at this point makes a clicking noise, would it be a good diagnosis to change the timer?
1 Answer Hello Mark. If there is power to the timer motor and it does not advance, you will need to order and replace the timer on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Dave May 07, 2011 for Model Number whdsr209g2ww The washing maching will not spin out the wash and rinse water. It agitates to wash and rinse. Could it be the timer?
1 Answer Hello Dave. This answer was located on our Repair Forum, this is a free service in which technicians will assist with answering repair questions for our customers. Please use this link to assist in your repair: http://forum.appliancepartspros.com/washer-repair/208433-washer-wont-agitate-spin.html . Make sure the switch is functional WH12X10531. Thanks! Read More...