Darlene February 05, 2018 for Model Number GSD820P-48BA Dishwasher makes a clanking sound when starting. It sounds like it is coming from the door panel. What could the problem be?
1 Answer Hello Darlene, You are most likely hearing the drain solenoid engage. This is located on the front end of the pump and motor assembly behind the kickpanel and is completely normal. Read More...
Brian July 01, 2014 for Model Number 3631441591 My Kenmore dishwasher # 3631441591 is not advancing through all cycles. All cycles work done manually with dial. It was working fine then just got hung up yesterday. I tried on different setting....pots/pans....normal wash All the same. It will wash for a while slowly advance then keep washing and the dial will not advance. Is this the timer? Is it a normal repair for this machine? I have had it for 20 yrs. no issue like this. If it is the timer what is involved to replace(difficulty factor)? Thanks Brian
1 Answer Hello Brian. It does sound like the timer. To replace this part, you have to disconnect the power and remove the inner door panel from the unit. Remove the timer knob. Next remove the control panel cover on the inside. Then you can access the back of the timer and replace the part. They are not real hard to replace. Read More...
Todd January 31, 2014 for Model Number gsd600L01 You list two different timers for my model number. How do I know which is the correct timer?
1 Answer Hello Todd! According to the model number supplied the replacement timer is part number WD21X626. Thanks! Read More...
Ty January 29, 2014 for Model Number GSD600L-01 You show two timers for under the listing for this model number. One is AP2039553 and the other is right below it in your online catalog. How do I know which one will work for my machine? Model number listed. Thanks....
1 Answer Ty, We were unable to duplicate your issue with the web site. We show one(1) timer available for the model number you supplied WD21X626 / WD21X626 part list number 904.We have also verified and compared possible issues with the manufacturers parts web site, and found none. If you order the AP2039553 timer, you will have the correct part, based on the available information. Thanks Read More...
1 Answer Hello Donald, Yes if the timer is not sending power to the pump motor then the unit will not pump the water. If there is power to the pump motor but still not pumping or operating then you would need a new pump or something is clogged in the pump. Read More...
1 Answer Hello Marie, Usually that would indicate that the timer is bad unless it's doing it in a cycle where the timer should stall and heat the water. We would really need the complete model # in order to give a better answer. After the GSD500 there should be a letter and than a few more digits. If you can provide that we'll try to give a more definitive answer. Thanks. Read More...