James May 25, 2023 for Model Number 77253600 My freezer frosts up, I can't seem to find a defrost timer... is this function controlled by the PCB
Tb January 14, 2018 for Model Number LG LDC22720ST/03 Refrigerator has stop running twice , but after unplugging and plugging back in it works fine. Is a certain part going bad?
1 Answer TB, For this issue the main control board will most likely be the issue with the unit. The main board is EBR41531303. Read More...
Eric June 01, 2016 for Model Number 795.77249600 Lights not working door switches have continuity.....circ brd issue?
1 Answer Hello Eric. If the bulbs and switches are good, you will need to replace the board on the unit. Read More...
Alfredo October 03, 2015 for Model Number LG LFD22860SW I noticed a burning plastic smell coming out when i opened door. I noticed the lights inside do not turn off when doors are closed. I can use water dispenser when doors are closed, which tells me the door switches are working.
1 Answer Hello Alfredo, There is a service bulletin on this unit with some part changes to prevent the interior light from melting the fresh food liner. The main board is changed to 6871JK1011G, the light has been changed to 6912JK2002E, the light display has been changed to ABQ33905306. The door switches are not the issue so it will not require attention. Read More...
Joe September 28, 2015 for Model Number LFD22860SW Internal lights are intermittent. I have traced the issue to the relays on the PCB(Main control board) can you tell me which relay/relays are responsible for the internal lights? Thanks
1 Answer Hello Joe. Sorry, the manufacturer does not offer the schematics for the control boards. Read More...
Rafael J. July 27, 2015 for Model Number LFD22860ST My water line to refrigerator broke and saturated the main PCB, 6871JB1375H. Now nothing functions except for the ice maker cube size light. I dried the board as best I could, but it still does not work. Would replacing the main PCB remedy my problem? Thank You
1 Answer Hello Rafael, Replacing the main board 6871JB1375H should correct the issue. I would make sure the connectors are all dry even if this means the use of a hair dryer so the new board will not fail from a cross circuit from moisture. Read More...
Patrick June 20, 2014 I have an LG fridge that cuts off and on, and the tech that came out said I needed a new PCB Assembly. The tech and the LG parts said I needed a 6871JK1011G, so I ordered it. It didn't fit! I talked to the tech again, and he stated that happens sometimes with the LGs. I looked at the PCB that I have installed in the fridge, and the number was 6871JB1375E. I Googled it, and most of them are out of stock, or it states I can use 6871JB1375H. I guess this is the replacement for the out of stock PCB I have. Is this true? can I use this one in place of the 6871JB1375E? Thank you!
1 Answer Hello Patrick. Based on the part number, you need to order 6871JB1375H for the unit. Read More...
Tom C June 02, 2014 for Model Number LG lfd22860st Hi, I have an LG fridge model lfd22860st, everything is running correctly on it, all the sensors are ohming the correct amount for temperature, but the freezer is at 50 degrees and the fridge is at 58. Could this be the main board or is it an coolant issue? Thanks Tom
1 Answer Tom, what you will want to do is pull the rear cover in the freezer compartment off and check the frost pattern of the evaporator coils. If there is a full even frost pattern then make sure the fan is running. If the frost pattern is just the top coil or top couple coils then the issue would be a leak or restriction in the refrigeration system. If the coils are impacted then would most likely be a defrost sensor issue. Read More...
Bob October 10, 2013 for Model Number 795773126011 Double door bottom freezer. Refer works fine freezer not cold enough. Condenser clean. Evap.. not frosted,.Fan motor running ok.Refdrig. is 37 Degrees
1 Answer Hello Bob. You have a sealed system failure and will need an HVAC tect to come and repair the unit. Read More...
Doby September 02, 2013 for Model Number LG LFD22860ST The lights don't come on when I open the door. I read on this site and heard from a technician that the PCB would need to be replaced. I bought this PCB (AP4443842) this past week and installed it in the fridge. The lights still don't come on when I open the door. The light bulbs work (if I move the socket around, the lights will sometimes come on) and the switches were replaced recently. Is there something else I should look at since the PCB doesn't seem to fix the problem?
1 Answer Doby, You will want to pull the light assembly down and check to see if your unit has a thermostat for the light sockets. If it does check the continuity and see if there is continuity. If not then you will want to replace the light assembly EAG62831801 Read More...