Scott June 05, 2023 for Model Number DLE2250W My dryer is running but not heating up. You suggested to run this diagnostic: press POWER while pressing the MORE TIME and LESS TIME buttons simultaneously Upon entering the test mode, the dryer cycled these codes in the display: ln:Ed ; U:02 ; d:02 Pressing start, resulted in the display starting at around the number 125, which quickly rose to 254, it would go to 253, then back to 254 Pressing start again resulted the display showing numbers 27-30, it would change every few seconds. Can you tell me what these codes mean? Thank you.
1 Answer Scott, Neither of these are error codes and are just the program and display versions for the board. If the unit is not heating it would be recommended to test to see if there is 240 Vac to the heater. If there is and the heater is not working then replace the heater. Read More...
Scott June 01, 2023 for Model Number DLE2250W I have an LG dryer. A few months ago, it stopped heating up, and the display showed the "Cooling" icon. So I purchased and installed a new heating assembly. Once I turned it back on, the heater seemed to work, but the display still showed the "Cooling" icon all the time. I didn't really care, because it was working. Now, the dryer is no longer heating, and the beeping tones are gone. So I purchased and installed a new PCB computer board. I got the beeps back, but it still will not heat. Any ideas on which part to replace next? Thanks.
1 Answer Scott,Based on the model number provided there is a diagnostic test mode for the dryer. It would be recommended to run the diagnostic test to determine any error or fault codes for your unit.To activate the test mode:1. The unit must be in standby mode (unit plugged in, display off)2. Press the POWER while pressing the MORE TIME and LESS TIME buttons simultaneously.3. Press the START/PAUSE button to advance through diagnostics. Read More...
Wanita February 15, 2022 for Model Number DLE2250W My dryer "starts", but only clicks when it is started. The controls all think it is running. The motor does not turn. The motor will operate separately, the belt and thermal overload are fine and the door switch is fine. When the dryer "starts" and "stops", it clicks about 3 times at the control panel. I think it is the control panel, but do not want to buy one if I am wrong. Any ideas?
1 Answer Wanita, If all things are working but the motor not turning when installed then this will be a control board issue. Read More...
Thomas December 16, 2015 for Model Number DLE2250W Why does my dryer drum continue to turn when the drying cycle is completed?
1 Answer Thomas, If the drum stops and then starts back up then the wrinkle guard feature would be on and this is what it is designed for. If it is just staying on running continuously then it would be a issue of a faulty control board. Read More...