Customer Questions and Answers for Washer Control Board by Lg

Jayson,

The main PCB for this model would be part number EBR32268019 and unfortunately has been discontinued by the manufacturer with no suitable replacement available.

Hello MadieBee,
you did not say after replacing the drain pump whether it was actually running when washer is in a drain cycle. If the drain pump is running but not pumping check for obstructions in the inlet and outlet hoses at the drain pump. If it is not running at all then check for 120v at the drain pump wire connection black and brown with washer in a drain cycle . If no voltage then the control board should be replaced.

Pete,

If everything was working prior to replacing the bearings then you would want to look for any wiring that may not have been reconnected or possible loose or damaged connection.

Ken, The "UE" code indicates an imbalanced load. If your'e sure the machine was loaded properly and evenly, and the washer doesn't make a rumbling noise when it did/does spin then you'll need to check the wiring between the control board and the RPS sensor on the motor for damage and proper connections. If OK, replace the 6501KW2002B Rotor Position Sensor Switch.

Ken,

You will want to check to check on the wires from the noise filter to the control board and see if there is 120 vac from the noise filter to the control board.

Hello Bob,
The EBR32268019 is the factory recommended part for the model provided.

Hello Kris. I would go back over the connections and see if one is bad or loose. If so it will cause the issue your having with the unit.

Khien siow,

The new main control board should have all the same connectors as the original control board.

Hello Chad! Yes, the PCB main assy EBR32268019 is the correct replacement board used on your LG washer model WM2301HW. Thanks!