Ted September 29, 2013 for Model Number LRSC26941ST Please provide me with detailed instructions on how to replace this part.
1 Answer Hello Ted, You will need to pull the unit out from the wall and remove the galvanized cover from the top rear of the unit. Remove the two water lines. These will be John Guess fittings. To remove the water line from a John Guess fitting, push the water line into the fitting and push the ring around the water line toward the water head. While holding the ring in, tthe water line will slip out. You will now need to go inside the fresh food compartment and remove the filter and the single screw above where the filter mounts. Re-install in the reverse order. To re-install a water line into a John Guess fitting, push the water line in until it bottoms. When you feel it bottom, push hard and the water line will "pop" in another 1/4 inch or so. This has popped the line into the seal. To seat the seal pull on the water line only. Read More...
James August 03, 2013 for Model Number LRBC22522ST My ice has been tasting terrible, people have told me to change my water filter. The issue I am having is that in all my searches I have yet to find the part number or location of the water filter for my fridge. Any help would be much appreciated.
1 Answer Hello James. Check and see if there is an external on the back of the unit. It does not look like this model uses one on it. Read More...
Mike June 22, 2013 for Model Number LG LFX21975-ST Hi, we went on a five day trip and upon our return the display had an ER code on it. There was no ice and the unit was not running, all the food was spoiled and when we called the LG support line I was told that it had something to do with the ice maker sutting the unit down.... just does not sound right to me, any ideas ?????????????
1 Answer Hello Mike. Depending on which ER code it was, there are 10 different things for 10 different ER codes. Read More...
Jim June 21, 2013 for Model Number 79575199401 Water filter hangs low so that filter cover will not stay closed. Can filter head "go bad" or is something else going on? All parts are original numbers.
Mari P May 28, 2013 for Model Number LFX25991st/02 I need to replace the water filter and don't know the part#.
Jim February 26, 2013 for Model Number LFX25971sb/03 What is the improvement for the water filter part 5231ja2006f over the 5231ja2006a. Thanks
1 Answer Hello Jim, There was not a change in the way that the water filter operates but there may be a design change in the way it is made but we would not have this information. Read More...
Dan November 01, 2012 for Model Number LG model LRSC26944TT I cannot get the replacement water filter to "lock in." It's the right filter - Original LG part # 5231JA2006B. It seems like it should go in just a bit further - where I'd feel the O-rings seat - and then twist to lock in. As it is, it won't rotate or lock in place. Jiggling around has been unsuccessful, as has O-ring/locking tab lubrication (with chapstick). If I slide the cartridge into the housing with the thumb-turn feature on the end of the cartridge in a horizontal orientation, it stops with about 1/2" of the cartridge body sticking out beyond the housing. When I rotate the cartridge so the thumb-turn feature is vertical, it goes in about half-way - leaving about 1/4" of the cartridge main tube exposed at the end of the housing. Visual inspection of receiving part still installed in unit shows no visible damage or irregularity. Is there some trick, a test, a possibility of a defective cartridge or?? Or should I just pull the receiver out for a better look? Thanks!!!
1 Answer Hello Dan. 5231JA2006F is the correct replacement filter for the model number you provided. Read More...
Gene October 23, 2012 for Model Number LG - LRSC26922TT i have no water entering the filter but i have water and ice. is there a bypass somewhere on the filter head or somewhere else. is there a clog that may have caused this?
1 Answer Gene, You're on the right track. You'll need to remove the lower shelves and crispers, and check the water reservoir(Tubing) to see if it has froze. If that's the csae, you'll need a blow dryer to melt the ice in the tubes, and reset to refrigerator temperature control warmer. Also check and make sure the articles on the shelves are not creating a blockage in the air flow. Read More...
Chente October 22, 2012 My fridge is working fine but on the water/ice dispenser there was an err ff code and the temp was rising so I had no ice. I disconect the plug and reconnected automatic turn on again for some hours . Could be the filter problem?
1 Answer Hello Chente, The Er FF code that you saw on your dispenser represents an error with you evaporator fan motor in the freezer. It is an indication that the control board was not sensing a rpm signal from the fan motor. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...