Sarah September 12, 2018 for Model Number DLE2516W Can the terminal block just be spliced in or does the entire wire harness need to be installed?
1 Answer Sarah,If your wires have burned off close to the terminal block just cut and install new connections. Always do a pull test on your new connections to ensure a good connection. Read More...
Daniel April 20, 2018 for Model Number DLE2516 The wiring harness that I needed is only from the back and goes to the control panel ,the light ,the door . I think I was sent the wrong part. What can make my dryer vibrate besides the dryer drum support rollers ?
1 Answer Hello Daniel. 6877EL1019D is the correct harness. You will need to check the blower wheel for excessive lint build up and clean it out to remove the vibration from the unit. Read More...
Shaun April 21, 2015 for Model Number Dle2101w When replacing the wire harness, should I replace the thermistor as well?
1 Answer Hello Shaun, If the thermistor is reading out of tolerance, replace it. If it tests within tolerance, it need not be replaced. Read More...