Ron Moniz August 30, 2017 for Model Number RS263TDPN/XAA To replace this part are the copper lines soldered together as mine look to be and if so would you lose the gas in the compressor and have to recharge it. Mine also is building up ice where the copper line comes in back with the black glob and silver tape around it is.This means there is a leak in this area? what would be required to seal it. Thanks
1 Answer Ron, For replacing the evaporator assembly it would be recommended to call service as the gas would need to be recovered and the unit pulled into a vacuum after the repair has been made. Read More...
Geoff A March 18, 2017 for Model Number RS267TDRS/XAA-0000 Every 3 months or so enough ice builds up on the top-left of the evaporator unit that the evaporator fan gets noisy and eventually stops moving. I have to use a hair dryer to heat the back panel and remove it to get at the ice block and then slowly melt it away before replacing everything. There are no error codes but I suspect it is either the defroster heater or the entire evaporator unit. Any suggestions on which to try replacing?
1 Answer Geoff, Normally an iceball where the lines come into the back of the unit for the evaporator would be a restriction in the sealed system and would need to have a service technician to correct this issue. Read More...
Mark December 21, 2016 for Model Number RS265TDRS/XAA Noticed very noise evaporator fan in fridge side. Removed panel to expose evaporator coil assembly and fan. Found large chunk of ice blocking fan from freely moving. Removed ice and fan moves very good now. However, when initially removing panel there was a black block that seemed to be helping to hold assembly in place located at approximately top left of coil assembly that fell apart. Could not tell that it was anything other than a piece of hardened black foam or plastic but wanted to make sure it wasn't something other than that. Thank you.
1 Answer Mark, Yes there are foam block(s) that are installed in the evaporator area, they usually don't deteriorate but they do serve two purposes. One is they do help to position the evaporator and help reduce the noise related to the refrigeration and cooling process. They also help to direct the air in and around the evaporator to improve the cooling process and efficiency of the refrigerator. If at all possible, you would want to reinstall the block, od as much of it as possible. Read More...
Blagoja Pancevski November 07, 2016 for Model Number RS265TDRS is the part Assy Evap Ref;sseda,ref, Part number:AP5651711 Made by: Samsung in fact evaporator together with defroster/heater for refrigerator Samsung RS265TDRS
1 Answer Blagoja, Yes the refrigerator evaporator assembly DA96-00681G is with the heater and sensors already on the evaporator coil. Read More...