Greg February 09, 2022 for Model Number samsung dryer DV520AE Hi after drying a couple of loads my dryer dry level selection is stuck in normal and the dryer will not start. happened before and after pushing the start button a few times it would start and complete it's cycle then it would work normal for a few more loads. any help to what I may need to replace .Thank you Greg
1 Answer Greg, With this issue, the display board would be the most likely cause of the dry level sticking. Read More...
Brian October 16, 2019 for Model Number DV520AEP/XAA02 Hello. Today I replaced the control board in my dryer with part # DC92-00322J because that is the part number that is on the original control board. Now I notice my model number isn't listed here. Is this the correct control board for my dryer? I replaced the control board because my dryer wasn't heating at all. Now I have heat but the dryer doesn't seem to be getting very hot. maybe 90 degrees out of the back of the dryer. Thanks.
1 Answer Brian,The thermistor reads the temperatures and tells the control if more or less heat is needed. You would need to check the resistance of the thermistor on the control at connector 4 between pins 3 and 6 which are blue and red wires. Disconnect the harness at connector 4 so you are only testing the thermistor. You should read about 10k ohms at room temperature. Read More...
Charles March 31, 2017 for Model Number Samsung Dryer DV520AEP/XAA-0002 This dryer does not heat at all and there is no error message on the panel. Other than that the dryer seems to operate normally. Every sensor in the dryer has been checked, including the thermistor and all seems to be good. The heating element is also OK. Seems I'm down to the main circuit board (not the ones on the front panel) as the problem. Any trouble shooting suggestions? Thanks, Charles
1 Answer Charles, There are 2 components other than the thermostats which would cause the heating element not to work. First is the motor and second the Control board. The best option is to disconnect the power to the unit and access the heating element. Disconnect one wire that is going to the heating element, preferably the one on the thermostat side. Plug the unit back up and using a multimeter you will want to turn the dryer on and test for 120 vac at the terminal on the heater where the wire was disconnected. What this will do is eliminate the heater element itself and the motor. If there is 120 vac at this point then you know the heater is good and the motor is good because the other 120 vac coming through the thermostats is the control board side of the circuit. If there is not 120 vac at that point then you will want to test the other terminal on the heater and check for 120 vac. If there is not 120 vac then the motor would be bad . Read More...