Ken March 01, 2021 for Model Number DW7933LRAWW THE DISHWASHER NEVER FINISHES A CYCLE, AND SHUTS OFF, ALSO I DID NOT SEE THE OTHER NUMBER AFTER THE SERIAL # , I COULD NOT FIND AA-0001,AA-01, WHAT IS THE DIFFERENCE? SO DO I NEED A PCB MAIN BOARD. THANKS
1 Answer Ken, It would be best to place the machine into test mode to see if you get any fault codes. Test Mode: Press the Heavy & Quick plus & power button for two-three seconds Read More...
Lon September 28, 2017 for Model Number DW7933LRASR The dishwasher soap dispensing unit will not open to release the soap. Purchased and replaced the dispenser but still not operating. Could this be a bad control board?
1 Answer Hello Lon. Check and make sure the wiring is good and if so, replace the board on the unit. Thanks. Read More...
Wesley September 13, 2016 for Model Number SAMSUNG DW7933LRABB Works but it wont stop running. lights go out like the cycle is completed but continues to run? Have to unplug it to reset it some times to get it going again. Would this be the control panel or control board?
1 Answer Hello Wesley. You will need to order and replace the control board on the unit. Read More...
Paul August 05, 2016 for Model Number DW7933LRABB/AA The dishwasher will not turn on. I hit the power button and nothing happens. The power is good going into the dishwasher. I checked the door switch and it has continuity across the micro switch. I am lost from there.
1 Answer Hello Paul. It sounds like the control panel DD64-00119B is bad and will need to be replaced on the unit. Read More...
Mdm December 20, 2015 for Model Number DW7933LRASR/AA-0001 Intermittent problem with dishwasher not filling with water when started. The Smart Wash button will start flashing and nothing happens. I have been able to "clear" this issue by depressing the power button and then depressing the "cancel and drain" button sequence then restarting the dishwasher and it takes off starting to fill with water and washes perfectly. A "service technician" from Sears came out and said It was a bad water inlet valve which I replaced. I checked the old valve and it ohmed out perfectly. Could this be a bad control panel, PCB, or sensor in the tube. The Samsung tech support is worthless and they really are not interested unless unit is in warranty. Any suggestions where to start? Thanks
1 Answer Hello MDM. Based on the information you provided, it sounds like the main PCB DD92-00033A is bad and will need to be replaced on the unit. Read More...
Phillip September 14, 2015 for Model Number DW7933LRASR/AA-0001 Dishwasher comes on water fills at bottom of dishwasher, then a few seconds later the pump comes on and pumps the water out of the dishwasher. This happens every time no matter what cycle I select, thanks.
1 Answer Phillip, This issue would most likely be caused by a faulty main control board. The part number for the control board is DD92-00033A. Read More...