Louis June 04, 2019 for Model Number SMH2117S/XAC I noticed that the microwave display for the time has dimmed significantly, to the point where it is very difficult to read. There appear to be 2 different PCB assemblies which could be causing this problem, however, I'm not sure which one to replace. One has the display, PN# DE92-02135B and the other circuit board seems to have the capacitors that could control the voltage to the display PN# DE92-02136B. Any ideas? The microwave model # is SMH2117S/XAC Samsung.
1 Answer Louis, you will want to test the voltage going to the display board at CN01 pin 1. It should be receiving 120VAC. If the control is receiving proper voltage, then the issue would be with the display assembly [DE92-02135B]. Read More...
Mark S July 18, 2017 for Model Number SMH9207ST I have this microwave, bought new, installed in NEW kitchen after move to new house. NEVER used prior to install in new house. program heating, runs a few seconds, then EVERYTHING DIES! no sound, no display, nothing. play with door will sometime reset it, not always. was told possible key pad or some PCB. is pcb (ML9P-0) in controller area responsible or is it the one in door? Will replacing door fix problem do you think???????
1 Answer Mark, You will want to check the wiring harness that goes from the door to the unit to make sure that there is no loose connections. If this checks ok then it will most likely be the control board DE92-02135A. Read More...
Wil September 21, 2015 for Model Number Samsung SMH2117S/XAC Hello While boiling some food (vapor) and then starting the microwave it stopped and gave a SE on the display. Nothing seems to clear the alarm. Powering off as well. Any thoughts?
1 Answer Hello Wil. You will need to order and replace the keypad on the unit. We do not offer Canadian parts. Sorry. Read More...
Jc August 10, 2015 for Model Number SMH9207ST/XAA-0001 Samsung microwave When you push the light button, the fan comes on.
1 Answer Hello JC. If the button is bad, then the membrane DE34-00333A is bad on the unit. This part has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. If it is not the membrane that is bad, then the board DE92-02136A will need to be replaced on the unit. Read More...
Danny K February 06, 2015 for Model Number SMH9207ST When I close the door on my oven it makes a humming noise. If I enter a cook time it works fine, but when it ends the transformer is still humming. I have tested the door switches and they all test good. I'm thinking it's the control board, part# DE92-02136A. What do you think? Thanks, Danny
1 Answer Danny, The transformer humming while the unit is not running would indicate that there is power getting to the transformer and would most likely be the control board causing this issue. Read More...
Walt March 15, 2014 for Model Number SMH9207ST Is part number DE92-02136A pcb power part difficult to replace?
1 Answer Walt, To replaced the control board assembly DE92-02136A, you will need to remove the air vent at the top of the unit. Once you have the air grill off, you would then remove one screw from the control panel. Once the control panel is removed you will be able to remove the control board. Read More...