Jason April 17, 2023 for Model Number NE58F9710WS The Oven Broil element goes on and stays on when baking. This is even happening when we use the lower oven.
1 Answer Hello Jason, the broil element relay on the main control board is sticking, the board is part DE92-02439G. Read More...
Steven January 03, 2023 for Model Number NE58F9500SS/AA-01 The oven overheats and burns food. Have cycled power at the breaker and the oven will work a time or two just fine. Then the overheating will happen again randomly.
1 Answer Steven, Thanks for the question!!! This is likely due to a faulty relay on the board DE92-02439G. Read More...
Den B October 20, 2022 for Model Number NE58F9500SS/AA-01 Our Samsung electric oven does not heat up for Bake or Convection Bake. The display will show that the temperature is raising, however the oven doesn't heat up (which we confirmed using a temperature gauge). At the same time Broil and Roast work fine. The stovetop works as expected. What could cause this issue? Thank you!
1 Answer Den B,Based on the information and model provided I would suggest checking the elements, and the oven TCO. After checking those check the wiring back to the relay board and then check for proper power from the relay board to the elements. Read More...
Kerrie December 20, 2020 for Model Number NE58F9500SS The broiler comes on randomly while I am baking. I researched a little and someone suggested pulling the plug for a little while which should "reset" the oven. That worked for a few weeks, but it has happened again. And this morning I was using the stovetop on low heat (4) making pancakes, I walked away for less than a minute and the burner got red hot and the pancakes burnt black. I double checked to make sure I hadn't turned up the temperature by mistake but the knob was still on 4.
1 Answer Kerrie, For the oven not working properly, the relay control board DE92-02439G would be the likely issue. For the issue of the top surface element going to high, this would be an infinite switch that is faulty and would need to be replaced. Read More...
Lawrence November 02, 2020 for Model Number NE58F9500SS The stovetop works fine, when using the oven it will start to heat up but then the display freezes and convection fans will run constantly, will start to work again when the oven cools in about one hour. When a malfunction occurs oven light does not work display blank and convection fans run.
1 Answer Lawrence, it would be recommended that the cooling fan DE31-00070A is inspected during this failure to identify if it is operating and allowing airflow to keep the control board cool. If it is not operating, the fan can be tested by removing the range back panel and testing for incoming voltage. If there is 120VAC, the cooling fan has failed and would need to be replaced. If it does not receive voltage, then the sub pcb assembly DG90-00877A has failed. Read More...
Thomas September 21, 2020 for Model Number NE58F9500SS/AA My Samsung oven does not heat up at all. The stovetop works fine. I have troubleshot and believe the control board is bad. How do I know what revision the stove is so I can order the correct control board?
1 Answer Thomas, The revision number would be located on the model tag and if there is no revision number go with the 00 revision. Read More...
Garrett Spraggins September 16, 2020 for Model Number NE58K9500SG/AA I get a E-0E alarm code. The motor that controls the door lock runs continuously, i tested and jumped out the contact attached to the motor, the motor runs regardless of the state of that contact. I think i need to replace the main control board but am having a hard time finding the part. None of the part numbers i see on your site match the ones on the control board. DE41-00461A. Also i think this stove is revision 03. Any help in finding this part would be appreciated.
1 Answer Garrett, According to the manufacturer, the correct main control board for version 3 would be DE92-03960G. Read More...
Phillip September 10, 2020 for Model Number NE58F9500SS/AA Follow up question. How do I determine the ver number of my oven. I see a model number and serial number on the sticker. There are no labels indicating version? In the same box as the model number their is a "01" in the upper right corner. Can I assume this is the version number you are referring to in the previous question?
1 Answer Phillip, The version number will be that 01 in the upper right corner. It may say Rev number but if not then that would be the number. Read More...
Phillip September 07, 2020 for Model Number NE58F9500SS/AA Two questions: 1) Is this the correct part for my model NE58F9500SS/AA? 2) The broil element does not turn on. Bake does turn on. I verified both elements test ok, I verified the temp sensor is ok (1093 ohms reading). Verified the bake element is getting 240v when on and the broil element does not have 240v when oven is on broil. Thanks Phillip
1 Answer Phillip, the main control needed would depend on the REV number of your model. The main control DE92-02439G would be used for Rev 00 through 02. The main control DE92-03960G would be used for REV 03 and higher. Read More...
Dan July 22, 2020 for Model Number NE58F9710WS On the PCB main assembly board part no AP5800583, there are relays for the heating elements. The broiler relay part number is GK A 1A 12D. I need just this relay. Can I buy that instead of the whole board?
1 Answer Dan,Unfortunately, a part of the board is not available by itself. The whole board would need to be replaced. Read More...