James Medlin December 14, 2020 for Model Number WA50F9A7DSW/A2-0000 The washer will not aloud the water to fill up tub. It gives a code of nF which is a solenoid water value. I replaced the valve in July 2020 and now it is doing it again 12/2020 .sometimes it works and how it only gives hot water at times Would this be. Control panel p/n AP5799764; mfg #DC92-01311c.
1 Answer James, You will want to test to see if there is 120 Vac getting to the water valve. If there is but no water is passing then it will be a faulty water valve. If there is no power then the issue will be a faulty main control board DC92-01021H. Read More...
Tony November 30, 2020 for Model Number WA50F9A7DSP/A2-0000 None of the touch pad buttons function. Washer will run but I can’t select any of the features on the touch pad. Thank you
1 Answer Tony, it sounds like the user interface has failed, you will need part number DC92-01311C Read More...
Tony November 29, 2020 for Model Number WA50F9A7DSW/A2-0000 Touch pads not responding to touch. Washer will start and run but the features on the touch pad will not respond. Thanks for your help
1 Answer Tony, This issue would most likely be caused by a faulty control panel which will be part number DC64-02898A which has been discontinued by the manufacturer with no suitable replacement available. Read More...
Wallace September 27, 2016 for Model Number wa5of9a7dsp/a2 Purchased 06/ 2013 program wash indicates 130 minutes takes 2 and 1/2 hrs and keeps repeating some stages makes grunging noises when impeller spins during pre soak, yet engages ok when spinning. i have already replaced the rods does this sound like main control panel prob? When put on manual spin only resets itself after half done to rinse and spin keeps adding minutes until it is done. Thank you, any help appreciated. Have watched youtube till eyes are crossed.
1 Answer Wallace, Based on the description this does sound like it would be caused by a faulty main control board part number DC92-01021H. Read More...