John May 01, 2017 for Model Number RB195BSBB Can you remove and replace only the heater on this da97-00192f by pulling it off the new unit and placing it on the old? As shown in this video of a different model: https://youtu.be/D__htvndaYQ
1 Answer John, It does appear that this is the style of evaporator that will be able to have the heater switched from one to the other. Read More...
John June 03, 2016 for Model Number RF4287HARS/XAA-0000 I have a Freon leak and had a technician who came out and found l leak in top evaporator coil and stated it was a 700.00 job. Is it feasible to get this repaired and does that repair price sounds right?
1 Answer Hello John, This price sounds average for a sealed system repair. This is an in depth repair that is very particular for the critical charge to circulate properly in the sealed system. Read More...
Cole May 22, 2016 for Model Number RB215LABP When buying this part does it come with an install instruction manual?
1 Answer Cole, No this evaporator assembly will not have an instruction manual to put it in. Unfortunately this is not information that we can provide and you would need to have a service technician to install the part. Read More...
Greg September 28, 2015 for Model Number RB215LAPB Should the heater on the evaporator coil in the refrig section show complete continuity? Mine registered 0.2 on continuity and 343 ohms resistence. Is that indicative of a fault in the heater? Thanks, Greg
Greg September 28, 2015 for Model Number RB215LAPB My refrigerator evaporator coil froze over twice now and caused the refrig temp to climb to ~56°F. The freezer section was actually too cold during this time...couldn't keep it above the minus range...sometimes -14°F and lower. The first time, I just cleaned everything really well and thawed it out. Everything worked for a couple of months but ice has built in the circ vents in the freezer during this time, as well as slowly building up on the coil in the refrig again. The second time, I noticed an error code indicating the thermocouple was bad. I have now changed out the TC and the thermal switch on the coil in the refrig. If it freezes over again, will I need to replace the heater itself? How can I check the control board first? Thanks, Greg
1 Answer Hello Greg. If the heater is good, you will test for power from the board to the heater by doing a forced defrost on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Israel Lopez June 21, 2015 for Model Number RB215LASH About 4 months I replace the temperature sensor and thermal fuse on my Samsung RB215LASH because the evaporator unit had frozen over and it had stopped cooling. Since then, I have had to manually defrost the evaporator coils two more times with a hair dryer to get the freezer to cool again. It seems it will work fine for a couple of months before the evaporator assembly freezes over again. Do I have a bad evaporator unit or this a symptom of something else?
1 Answer Isreal, The most likely cause for the evaporator to not defrost would be a bad heater loop or a faulty control board. The heater loop is part of the evaporator assembly. Read More...
Justin June 10, 2015 for Model Number RB215LASH I have a Samsung rb215lash it gives me the error code condenser fan but it runs. I replaced the motherboard, both freezer probes and thermal fuse. The freezer freezes solid in about 3weeks but the refrigerator hold temp just fine. What next I am at a loss
1 Answer Justin, If you are getting a condenser fan error code then you will want to test the voltage at the main control board for the fan motor. The fan voltage at the Main PCB should be between 7 and 12 vdc. If the voltage is not correct then the fan motor or the wiring would be the cause of the failure. Read More...
1 Answer Hello Manh! As for the images we have available, one has orange/brown wires and the other has brown/white wires. We do not have the specs to verify the exact difference. Sorry! Read More...
Jerry March 14, 2015 Is it difficult to put in an evaporator assembly, or should I get a tech to install? I have done plumbing repairs and general electrical work.
1 Answer Hello Jerry, If you are not Freon certified by the EPA, you will need to hire the job out to stay within the law and get a proper result, since there are several specialty tools you will not have such as a recovery system, torch set, and vacuum pump. Read More...
1 Answer Amy, the defrost heater for the freezer is only available with the evaporator assembly part number DA97-00192F. Thanks! Read More...