Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Refrigerator Defrost Heater by Samsung

Best Seller
Manufacturer Part
4.89 (64)
By: Samsung
Part Number: OEM12413268
Manufacturer Part Number: DA47-00154A

Freezer icing up or refrigerator not cooling? A failed defrost heater allows frost buildup on coils. DIY-friendly repair, typically 20 minutes.

More
$77.95

IN STOCK
Ships Today Guaranteed
Add to Cart

Questions & Answers

For Samsung Refrigerator Defrost Heater (Part Number: OEM12413268)

1 Answer

Bill,

You will want to clean out the ice from the drain inside the refrigerator section and then clean out the drain tube at the back of the unit. Once this cleaned out flush the drain with hot water and install the drain clip part number DA61-14306A.

Read More...

1 Answer

Antonio, Thanks for the question!!! The heater is rated for 300W and 115v, which means it would be approximately 44 ohms.

Read More...

1 Answer

Bob,
If the fan is not running or running fast enough it could be the cause of the freeze-up, I would start by replacing the fan motor.

Read More...

1 Answer

K, the defrost drain would need to be inspected for water standing in the drain as this can cause excessive frost to accumulate on the evaporator. If clear, the next step would be ensuring the defrost sensor is on the larger tubing of the evaporator. The defrost heater can be tested for resistance and it should measure 120 Ohms.

Read More...

1 Answer

Ellie,

If only half of the display is lighting up then this would be a faulty dispenser control board. The part number for the dispenser is DA97-08118P but unfortunately has been discontinued by the manufacturer with no suitable replacement available.

Read More...

1 Answer

Mike, The defrost heater in the refrigerator should have a resistance of 120 ohms, and the freezer heater would be 60 ohms resistance(+/- 5%). Test mode (manual operation / manual defrost function) " If Freezer Key + Lighting Key on the front of panel are pressed simultaneously for 8 seconds , it will be changed to the test mode and all displays on the front of panel will be off. If any key on the front of panel is pressed within 15 seconds after the test mode, it will be operated as below sequence : Manual operation1(FF) Manual operation 2(OF r) -> manual defrost of fresh food compartments(rd) -> manual defrost of fresh and freezer compartments(Fd) -> cancel(Display all off) . If any key on the front of panel is not pressed within 15 seconds after the test mode, the test mode will be canceled and it will be returned to previous mode."

Read More...

1 Answer

Thomas,

If the condenser fan motor is running slow then the condenser fan motor would be faulty and need to be replaced. This fan running slow will cause the compressor to overheat.

Read More...
Rob P for Model Number Samsung RF266AEPN

Noticed a couple of days ago that just the freezer is not working properly. When I first noticed the problem the freezer temp was blinking. I unplugged the the fridge for 10 minutes and the temp showed to be in the mid 40s F for the freezer. I waited a few hours and it only moved down by 10 degrees or so. The food was not completely frozen and noticed that things toward the back of the freezer seemed pretty icy as well. Based on what I am reading online it seems that the defrost heater may be going bad? Like I mentioned above the fridge seems to be working great. If there are some other parts that I should get as well to do some preventative maintenance I would like to do that now as well. I have read that Samsung has some problems with temp sensors.

1 Answer

Rob

You will want to check the defrost sensor as being a possible problem with the unit or the defrost heater. If they both check ok then the issue would be the control board but is likely one of the other parts.

Read More...

1 Answer

Hello Mito! Unfortunately, the model number given is showing to be an international model and unfortunately, we do not have a parts lists available to verify compatible parts. Sorry about that!

Read More...
Charles for Model Number RS2530BWP

My refrig. model number is RS2530BWP. It was not cooling properly and the freezer was not at freezing temp. The back of the freezer was completely iced up tho. I had a refrig. repairman come in and his diagnosis was a bad heater. He did not say anything about the sensor element. The only heater that seems to come up is part number AP4137753 (which it says is not compatible with my model number). Do you have a heater that is compatible. Is there any way of checking the sensor? How about the heater? I have since bought a new fridge but would like to get this one fixed.

1 Answer

Hello Charles,
The defrost thermostat DA47-10160F should be closed when below about 20°F. It will read open if warmer and it is not possible to tell if it is good or bad. The correct heater is DA47-00154A. We apologize for this but the compatibility tool is still in work and should not be used since it still is not recognizing all parts and model numbers.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google