Ray December 13, 2018 for Model Number RFG295AARS/XAA-0000 This is a follow up to a question I asked yesterday. I checked the voltage on the main board and was getting 10.6v at the gray & orange wire and 7.6v at the gray and brown wire. I then pulled the metal cover from the interior of the refrig where the defrost sensor plugs in and tested the ohms and at 68 degrees it was reading 7.2k. I plugged every thing back in and all of a sudden my evap fan started running. I put in on the quick cooling and the refrig reached 38 degrees within a few hours. At this point everything is working perfect both refrigerator and freezer. The fans are running and the temps are where they should be. Fast forward to this morning the fan was running in the refrigerator normal but the temp was back to 52 degrees. I'll pull the back cover when I get home tonight to see if I've got freeze up on the coils but am at a loss on what's causing this. The defrost coils are working fine.
1 Answer Ray, This issue would most likely be caused by either a refrigerator temp sensor that is faulty or a main control board that is not reading the correct temperature in the refrigerator section. Read More...
Ray December 11, 2018 for Model Number RFG295AAWP/XAA-0000 My refrigerator is only cooling to 52 degrees but the freezer is working normal. My evaporator fan on the refrigerator doesn't engage but when removed does operate at 12v. I tested my Thermistor and at 70 degrees it's registering at 6.12 ohms and does fluctuate with temp changes. What is the likely issue as my fan doesn't receive a signal to turn on?
1 Answer Ray, it sounds like the evaporator motor is not receiving voltage from the main control board. Anytime the compressor is running, the evap. fan motor should be running. You should read about 9 VDC. If you get 3 seconds of voltage every 10 seconds, then the control board id good Read More...
Don November 08, 2017 for Model Number RFG295AAWP/XAA-0000 Refrigerator warms about 10 degrees before it turns on. It cools fine. Would this be he temperature sensor
1 Answer Don, The temperature sensor could be an issue with the unit. You will want to test the sensor for 5K ohms at room temp. If the resistance is good then this will be a control board issue. Read More...