Anne October 16, 2022 for Model Number samsung RF266AEWP/XAA Freezer doesn't get cold. Refrig works fine. PCB inverter board shows a solid red light. Power board no light. Sensor in back panel yellow wires, approx 5000 ohms. New thermostat purchased and installed in back of the back panel. Have not tested sensor by the light in the freezer ceiling. how do you test this? Could this be the problem?
1 Answer Anne,Check the tech sheet packaged with the machine for the proper resistance for the sensors. Then check each of the sensors for the proper resistance...the 5k for the one you listed does not sound correct. Test and replace sensors as needed. Read More...
Don July 01, 2022 for Model Number RF263AEWP/XAA Freezer is kinda frosty and after turning off the ice maker and turning it back on ... we no longer get any ice. I was thinking the problem was that the freezer temp sensor was bad. I actually have the freezer set for 4F and that seems bout right. So ... do you agree that this is probably the temp sensor ... part 14 I think in the diagram? Also, I can't tell where it is located. Think you can give me an approximate location? We are always overloading our freezer and I've heard the wiring could snag and fray. Big thanks ... Don
1 Answer Don, Thanks for the question!!! The sensor would be located in the evaporator cover. This sensor should not keep you from making ice or making the freezer frosty. Frost would be a defrost issue or an air leak. Verify temperature in the freezer is correct. Located the tech sheet for your fridge and run a diagnostics mode for error codes. Read More...
Tony December 10, 2015 for Model Number RF263AERS/XAA-0001 DA32-00011C DOES NOT HAVE THE SAME CONNECTOR AS THE ONE IT REPLACES. WHAT DO YOU DO?
1 Answer Hello Tony. You can cut the old connector off and splice it into the new sensor on the unit. Read More...