Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Agitator Lower Part by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18024153
Manufacturer Part Number: WP3350830

Fixes broken or worn agitator fins causing poor wash performance. Direct replacement for washer agitator base. Moderate DIY repair, 30-45 minutes.

More

Questions & Answers

For Whirlpool Washer Agitator Lower Part (Part Number: OEM18024153)

Pete for Model Number LXR9445JQO

I wish to replace my agitator with perhaps a cross fit lower unit that DOES NOT HAVE the open slits or gaps between the base and fins. Previous and newer models have the fins extending and attached to the loser base. We believe some of the clothing damage and tearing experienced in this model is caused by items getting snagged in this gap. We need to see if newer lower units (that will fit this model) are available that do not have the open gap between the fin and base. Can you help? Pete

1 Answer

Hello Pete! Unfortunately, the can only suggest and guarantee the original agitator as being compatible that will fit your model. Sorry!

Read More...

1 Answer

Lynn,

You would need to check to make sure that the suspension spring to make sure that it is in place. Also check for damage to the skate place.

Read More...

1 Answer

JA, Here are the basic instructions, be careful, don't loose any of the small parts, "1. Place a screwdriver blade in the notch in the auger.
Twist the screwdriver gently to pop the outer cap or dispenser off. 2. If agitator has an inner cap and seal, twist and pull up to remove.
3. Unscrew the agitator mounting bolt, and remove agitator. 4. Firmly, but gently, pull up on the auger. This will free the two (2) lock tabs on the bottom of the cam from the two (2) tabs on the agitator base. 5. NOTE: The two (2) tabs that hold the cam to the agitator are for factory use only. The tabs are not needed for agitator operation. Bend the tabs to break them off and remove. 6. Set the thrust washer in the slots on the top of the agitator. 7. Set the auger and cam on the agitator. 8. Replace the agitator and mounting bolt. 9. Check to be sure the auger turns. It must only rotate clockwise. 10. If agitator has an inner cap and seal, wipe a few drops of liquid soap on the seal of the inner cap, then push the inner cap down into the auger. The seal MUST be seated to the groove in the auger. Turning the cap will help to seat the seal. 11. Snap the outer auger cap or dispenser on. There is a video instruction attache dto this part number, that should help as well, 285811 , Thanks and Good Luck

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google