Mike February 14, 2022 for Model Number AL5143VW1 What no dogs? yeah I'm looking to repair this Roper and I'm going to need a new filter and it just doesn't seem that that there ARE any dog action. A screw actually goes thru the upper agitator to lower agitator only and the video shows a different set up! -is that right?
1 Answer Mike, This would be correct. Your agitator is a different design that does not require the use of agitator dogs. Read More...
Dorothy June 25, 2021 for Model Number inglis x043000 washing machine The lint trap inside the upper agitator of my old washing machine fell apart. I no longer have a lint trap and the top part of the agitator comes loose during a wash and bangs around. Will this fit snuggly in my inglis x043000?
1 Answer Dorothy, The model number listed is not correct and we will need to have the correct model number of your washer to be able to assist properly with your question. Read More...
Gilbert September 07, 2015 for Model Number Inglis Liberator washer machine X043000 Hello. I would like to know : for an old Inglis Liberator X043000. Is it possible that the lint filter would be attached directly to the agitator without the upper agitator kit. Part Number : 63751-W. great video. Many thanks.
1 Answer Hello Gilbert. On some of the older models, the filter was part of the agitator. Read More...
Steve M. May 28, 2012 for Model Number LA8200 XWW1 Bought this set but the filter part (top piece) dosen't fit very tight. It comes off in the spin cycle & bangs around in the tub. It seems to fit on the old agitator but that one is cracked. I had one of these sets replaced already becaused it was broken when I recieved it. It dosen't fit tight on that agitator either. Not sure what to do ? Please help
1 Answer Hi Steve. Make sure the 4- locator tabs under the agitator part # 387838 are all placed correctly as you align the agitator on the shaft. Then Follow the service manual instructions... "Manual clean lint filter- Clean the filter at the bottom of the agitator after every load for the best filtering results.To clean: 1. Lift off the agitator barrel. 2. Wash or wipe the filter clean in the bottom of the agitator barrel. The filter is not removable.3. Replace the agitator barrel and snap lint filter it into place." Make sure it snaps into place firmly or it will come off. " Thank You. Read More...
Moon December 01, 2011 for Model Number LA5100XTW1 The upper agitator seems to have a screw on the side holding it to the lower agitator. The screw hole seems to be stripped and now it keeps falling. This washer was purchased used and may have been modified. What are your thoughts?
1 Answer Hello Moon. Based on the information you provided, it sounds like the agitator 387838 is bad and will need to be replaced. Hope this helps. Read More...