Gloria July 14, 2014 We have a whirlpool top mount refrig and the bail arm of the ice maker came loose?? Can we put this back in place???
1 Answer Hello Gloria. Yes, the bail arm snaps into a hole at the module head of the icemaker. Read More...
Terry June 05, 2014 for Model Number MZD2665HEW Yesterday 6/4/2014 I took ice from the ice bin by hand to fill up my 1 gallon water jug. The ice maker has not made any ice since then. What did I do that turned the ice maker off? The bail arm was in the down position all day. Thank yo, terry
1 Answer Terry, You will want to make sure that the bail arm did not come loose and the icemaker actually in the off position. To find out you can pull the icemaker out and make sure that the bail arm is in the little brown slot on the back of the housing and then make sure it is down. If this is ok then you would want to pull the front off the icemaker and check the pins in the center of the large wheel. If the pins are pushed together or one of the 2 are missing then the icemaker module W10190935 would need to be replaced. Read More...
Fred June 10, 2012 for Model Number ARS2426BB After installing and pushing the bail arm down, the ice maker makes ice the, arm moves up after about 10 minutes.How do I keep the ICE maker to continue making ICE and stay down to fill container. Thn ICE maker only has about 2 inches of Ice in the container and does not make ice again until I push the bail arm down again. You suggestion? Thanks
1 Answer Hello Fred. Check and make sure the arm WPW10152975 is installed properly into the icemaker module, and springs down when released and does not feel tight. If it is good, you may need to replace the icemaker on the unit due to it being bad on the unit. Read More...
Fred June 08, 2012 for Model Number ARS2426BB Bail arm.. after install arm/bail, how do I start ice maker... do I just push arm down? How do I know if arm is in the ON position? I have seen your photo...is the arm /bail in the On position in your photo's? Does the right side arm change position or does wire just move? Thanks
1 Answer Hello Fred. Just push down the arm and the wire on the arm just hangs there. This turns the icemaker on and the wire hanging is a feeler for the level of ice in the unit. Read More...
Fred June 07, 2012 for Model Number ARS2464BC (BOM: PARS2464BC0) I need installation instructions for this part. I need to know what it will look lilke when it is on. Thank you.
1 Answer Hello Fred. The end that has the waves in it inserts in the white hole on the module head and the smooth end of the bail arm WPW10152975 inserts into the fill cup. You can see the bail arm installed on the icemaker in these pictures W11700559. Read More...
1 Answer Hello Richard. You will pull out the end going into the icemaker head, and then pull the other end out of the fill cup. Install the new arm WPW10152975 in reverse order. Read More...
Bobby November 10, 2011 for Model Number PSD268LGES Do I need the thin wire that comes with the Bail Arm? Mine does not show the thin wire that is attached to the Bail Arm as shown in your diagram.
1 Answer Bobby, No, you don't have to have the thin wire that's attached to the new bail arm. It actually reduces the amount of ice produced, when positioned and "locked" in place on the bail arm. Thanks and Good Luck Read More...