Fredda October 22, 2012 for Model Number LNC6760A71 I GOT MY GOLD CHAIN CAUGHT UNDER THE BASE OF MY AGITATOR, I'VE TAKEN OFF THE SOFTENER CUP AND THE ROCKET PART BETWEEN THE CUP AND THE BASE BUT i CAN'T GET THE BASE OFF. CAN YOU PLEASE HELP ME!
1 Answer Hi Fredda, once you remove the bolt that holds the top part of the agitator, the bottom piece just lifts up. You may have to work it some to get it loose. Hope this helps! Read More...
Briam July 15, 2012 for Model Number MAVT 236AWW Can you take the agitator out and run a cycle without damaging the unit to see if the transmission is bad or the splines on the base?
1 Answer Hello Briam. Yes, for testing purpose, you can remove the agitator 21001530 and run the unit. Read More...
Jerry February 09, 2012 for Model Number cw5500w The washer fills,spins and drains but when it trys to wash the agitator doesnt move but makes a loud ratcheting sound. I took off the agitator and ran a wash cycle and the agitator base made the same noise. What would I need to replace?
1 Answer Hello Jerry. If the agitator base 210381 is good in the unit, you will need to replace the transmission 35-6615, based on the information you provided. Hope this helps. Read More...
Lateshia August 13, 2011 for Model Number LNC6766B71 My base came off and I can't get it back down. Is there a certain way to put it back on?
1 Answer Hello Lateshia. Yes, you will need to line up the splines of the agitator 21001530 with the splines of the transmission. Once they line up, the agitator base will push down. Hope this helps. Read More...
Jackie June 03, 2011 for Model Number PAV5157AWW My washer does not agitate. It only spins. Will this part repair the problem?
1 Answer Hello Jackie. You will need to check and see if the thrust bearing is wore and bad. If so, you will need to replace the thrust bearing 12002213. If it is good, then you may have a bad transmission 35-6615. You can check the splines inside the agitator base and see if they are stripped out. Hope this helps. Read More...
1 Answer Hello Rick! You will need to remove the fabric dispenser cup from the top of the agitator. You will find a bolt at the center of the agitator. Once you have unscrewed the bolt the agitator and base should lift right up. You might need to apply force to remove the base, could be a little stiff. Thanks! Read More...