Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Door Boot Seal by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18052551
Manufacturer Part Number: WPW10237494

Creates a watertight seal between the tub and door opening. Replace if torn, cracked, or leaking water. Verify fit with your model number before ordering.

More
$161.92

IN STOCK
Ships Today Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Washer Door Boot Seal (Part Number: OEM18052551)

1 Answer

Hello Jason. 1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover and the console.
4. Remove the lower front access panel.
5. Open the washer door.
6. Using a small screwdriver or a pair of
long-nosed pliers, pull the tension spring
on the retaining wire out from around
the front of the bellows WPW10237494, and remove the
wire.
7. To remove the door switch assembly:
a) Pull the bellows off the lip of the front
panel beside the door switch assembly
just enough to access the switch
assembly.
b) Remove the two T-20 Torx screws
from the door switch assembly.
c) Pull the door switch assembly out and
turn it over so that you can access the
connectors.
d) Unlock the tabs and disconnect the
three wire connectors from the door
switch terminals, then remove the assembly.
8. To remove the bellows:
a) Remove the two T-20 Torx screws
from the door switch assembly.
b) Remove the front panel from the
washer.
c) Turn the bellows retaining clamp screw
counterclockwise until the clamp is
loose enough to remove it from around
the bellows.
NOTE: It may be necessary to completely
remove the screw from one
end of the clamp.
d) Remove the bellows retaining clamp
from around the bellows.
e) Pull the bellows off the front of the
tub.
REASSEMBLY NOTE: When you reinstall the
bellows, be sure to position the “weep holes”
at the bottom, as shown below. Hope this helps.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google