Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Cleaner by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM20506731
Manufacturer Part Number: W10549845
$10.64

IN STOCK
Ships Tomorrow Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Cleaner (Part Number: OEM20506731)

1 Answer

Stitches,

It does not sound like you did anything wrong with the setting and may not have been very dirty. It would not be recommended to reuse the tablet as the chemicals in it have been activated once it got wet.

Read More...

1 Answer

Catherine,

There is no expiration date on the affresh cleaner and it sounds like you may not have been using hot enough water.

Read More...

1 Answer

Hello Donn,
Several things can contribute to odors in a dishwasher. One is oversoaping. Several others include the types of foods put into the unit, the proper placement of the drain hose so the unit drains properly, and water temperature. While these are not the only contributing factors, they are the most common. To rid the unit of much of the problems, always use as little detergent as possible, always use the heat assist wash cycle, and always scrape off the excess and only allow enough food particles to remain to occupy the chemical reaction produced by the detergent when it reaches 140°F.

Read More...

1 Answer

Hello Susan,
If failure F35 is displayed, there a malfunction of the steamer component detected by the Steamer Electronic Board. Check if pressure hose is connected correctly. Check if the airtrap is not blocked. Check if the hose is not blocked. The SUD code indicates that suds are detected continuously by the pressure switch during the drain or spin phases, the washer will fill 4 liters of water and during 5 minutes
the unit will rest without tumbling, the water will be drained and it will try to spin or drain again. Possible Causes/Procedure: If too much detergent was used: Run through a RINSE/SPIN cycle. Run a NORMAL cycle without adding any detergent. This should clear the unit of the excess detergent. Check the drain hose and make sure it is not plugged or kinked. Unplug washer or disconnect power. Check wire harness connections to the drain pump, pressure switch, and Central Control Unit (CCU). Check/clean drain pump filter of foreign objects. Plug in washer or reconnect power. Check drain pump. Check the pressure switch. Verify CCU operation by running a Diagnostic Test or any cycle.

Read More...

1 Answer

Hello Rizwana! You can use vinyl touch up paint part number WP676453 to cover the rust and tine tips part number 675679 to help cover the damaged tines from further damages. Hope this helps you, thanks.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google