Lynn December 15, 2021 for Model Number CWG3100AAB What does an F-3 Error indicate? The heat sensor was replaced and the error still appears. (Maytag) CWG3100AAB
1 Answer Lynn, the error F3 indicates that the control senses an open sensor. As the sensor has been replaced, the oven control 12001620 has failed. Unfortunately, this part has been discontinued by the manufacturer and is no longer available. Read More...
Joe Rossi November 09, 2016 for Model Number cwg 3100 aab The upper arrow on the timer advance or temperature control will not advance when pushed in . the bottom arrow works fine . cannot find replacement part
1 Answer Joe, The part number that you would need is the clock assembly 12001620 which unfortunately has been discontinued by the manufacturer with no suitable replacement. Read More...
Stan Gardner October 04, 2016 for Model Number Model #CWG3100AAE Ser # 12451411QY Failure of the control assembly is due to a faulty microprocessor (the brain of the control #12001620). Are microprocessor's available. If so, where? Can a DIY person replace it?
1 Answer Stan, The microprocessor in the board being faulty will require a new control board to be replaced as the parts are not available separately. Read More...
Shelley August 12, 2016 for Model Number CWG3100AAB Get F7 code, and beeping-til I turned the breaker off for oven.
1 Answer Hello Shelley. Function Key Shorted. A shorted function key prevents recognition of the cancel key and requires removal of power until serviced. The part needed 74001408 has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Read More...
1 Answer Hello Kai. Sorry, this part has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Read More...
1 Answer Hello Alysia. Sorry, This part has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Read More...
Victor August 24, 2013 for Model Number wg3100aab Clock assembly 12001620 part Number AP4009450 is not available is their a replacement
1 Answer Hello Victor, Unfortunately, the manufacturer has dis-continued this part and they listed no satisfactory substitution. The only recommendation we could make is to do a search online for companies such as corecentrics who re-manufacture electronic control boards. Read More...
Mark February 11, 2013 for Model Number CWG3100AAB We have a fault code of F 5. We replaced the igniter and the heat sensor. What should we do now?
1 Answer Hello Mark. Control Output Disabled. You need to replace the control in the unit. Read More...
Brent May 12, 2012 for Model Number cwg3100aab My oven will clock goes off occasionally after heatup.Clock will just go blank but you can bump it with your hand and digital readout comes back.Oven has to then be reset.Any suggestions on the problem? Thanks.. Brent
1 Answer Brent, Since this seems to be "heat related", your first check should be at the Black (L1) and White (N) wires and the connections at the control board(clock) Check the "crimps" on the wire terminals (frayed wires, loose fit, etc.) and for tight connections on the control board terminals. Check the same wires, for a similar situation at the main terminal block. If alls OK, then replace the control 12001620 Thanks and Good Luck Read More...
1 Answer Hello Keith. You will need to disconnect the power to the unit for about 15 minutes to rest the clock 12001620 in the unit. Hope this helps. Read More...