Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Electronic Control Board by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM11329962
Manufacturer Part Number: 280087

Questions & Answers

For Whirlpool Electronic Control Board (Part Number: OEM11329962)

1 Answer

Hello David. Those are special run stickers for the manufacturer. They do not apply to the part. If your control interface is black, you will need to order 280087. Thank you.

Read More...
Bill T for Model Number 110.85876401

I went on a service call on this sears Kenmore dryer. the unit is completely dead Has 240 going to the dryer. Has 120 at the main control board. display is dead no response on the touch panel. I ordered the main control board wp8546219 I still have the same symptom. would you suggest the display board ap3776651 or could it be possible that the main control board I received was defective out of the box? I ordered the part from appliancepros.com . I don't have a schematic for this product. I also noted drum light was not operating. could a door switch cause a completely dead symptom. no lights or display. please advise me. Thank you for your help.

1 Answer

Bill,

With the display board not working and the main board getting 120 vac to it, then it sounds like the main control board may be defective. The door switch would not cause an issue with no power.

Read More...
Brian for Model Number 101.85866401

The dryer makes a beeping sound while it is drying. The sound pattern is the same as trying to push a button while it's in mid-cycle. However, when I push cancel, the dryer stops and all the lights on the front panel go out. When I try to select a new cycle, I get no sound and no lights and cannot start a cycle (it still has power - the interior light comes on when I open the door). Usually, if I unplug the dryer for a few hours, it will work fine again until halfway through a drying cycle (doing the same thing). I get the same result running the dryer empty. Is this an interface board issue or a main control board issue?

1 Answer

Jacob,

The most likely cause for the unit to not have anything but a dim display on one of the keys and nothing operating would be a faulty control board WP8546219.

Read More...

1 Answer

Conrad, To access the thermostats, you'll need to remove power to the dryer and remove the dryer lower front panel, you'll find the thermostats and fuses mounted to the heater cone assembly and the blower housing. to access the user interface control and the machine control board, you'll need to remove the top panel of the dryer,three screws across the back of the top panel, and slide the panel back to unlatch the front retainers. When you remove the lower front panel, you should find the wiring diagram and test information in a plastic wrapper attached to the back side of the panel. You'll be able to test and varify the dryer operation.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google