Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Main Control Board by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18853500
Manufacturer Part Number: W11162438

Fix a washer with no power, stuck cycles, or unresponsive controls by replacing the main control board. Moderately difficult repair for most models.

More
$262.25

IN STOCK
Ships Tomorrow Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Washer Main Control Board (Part Number: OEM18853500)

1 Answer

Hello Eric, and thank you for choosing AppliancePartsPros.com. It sounds like there is an issue in the main control W11162438.

Read More...

1 Answer

Hello Tim, check if the drain pump is still functional, or if there is standing water in the tub that has not pumped out yet, ,if so the control board will disable all functions except the drain pump and will enter a 15 min pump out mode that it will need to finish out uninterrupted then it will reset itself.

Read More...

1 Answer

Shirley, the lid lock should lock when start is pressed, it will unlock briefly, then it will lock again before proceeding through the sensing and filling portion of the cycle. It would be recommended that the lid lock W11307244 is tested to identify if it is operating properly. With the washer power cord unplugged and the lid down, the main control W11162438 would be accessed and the wires at connection J6 will be used for testing. From the blue wire to the white wire, there should be a resistance reading between 85O to 155O. When the lid is lifted it should read open circuit. If the lock tests within the proper range, then the failure would likely be in the main control.

Read More...

1 Answer

Hello Lynwood,
remove the back panel of the control panel to access the control board. with a multimeter check that there is 120v at the J5 connector. There is a small LED indicator in the middle of the rear of the control board that should be lit. If it is not and the 120v has been checked then disconnect the other wire harness connectors one at a time and see if the light comes back, if not then the control board W11162438 has failed.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google