Rocco October 04, 2026 for Model Number MVWB765FW3 When I power my washer on in normal wash position, I press start the start button and lid lock light blinks, the display shows 52 minutes but then everything goes dark. It comes back on a second or two later, the lid locks and the cycle starts. Any ideas of what the issue might be. I'm leaning towards the main control board.
1 Answer Hello Rocco, thank you for reaching out to AppliancePartsPros.comIf the washer is working and running cycles we would not have any suggested repairs. It is likely that the manufacturer would consider this normal operation. Read More...
Chris October 29, 2025 for Model Number MVWB765FC3 Do you have knowledge of instructional videos for changing control panel?
1 Answer Chris, Thank you for your question. Here is a video that will give a general idea of replacing the control board. https://www.youtube.com/watch?v=xB-IDOOk_dc Read More...
Julio August 10, 2025 for Model Number MVWB765FW3 The washer turns on but won't start. I put it in diagnostics mode and got F0E3. Would I need a control board?
1 Answer Julio, The F0 E3 Error is an overload error. The faulty is displayed when the board detects that the load size exceeds the washers capacity or that the basket cannot be turned. Make sure you are not overloading the unit and if not then check for mechanical friction on the drive system or basket. Read More...
Chris Brock January 23, 2024 for Model Number MVWB765FW3 Power turns ON. Lights Lite up. but Start button Does NOT start the machine.... Just finished working for 1 week after this happened (stopped starting) last week. Is it the "Module'' or the button for the START? pls advise. ty cb
1 Answer Chris, It would be recommended to get the tech sheet from inside the unit and check to see if there are any error codes. These will guide you to the problem with the unit. Read More...
Tim January 04, 2024 for Model Number MVW8765FW3 The washer will come on. the lights come on but the washer will not start and run. If you keep messing with the start button if might work.Showing a E-1 F-3 code.
1 Answer Tim, the pressure hose and port would need to be inspected for any clogs or pinholes. If the pressure hose and ports check good, the failure would be in the main control W11429620. Read More...
Keith May 20, 2023 for Model Number MVWB765FW4 My washer will not complete a cycle. I can manually force it to, but it will not do it on it's own.
Bob May 20, 2023 for Model Number MVWB757JW0 My washer seems completely dead. My repairman said I need the control. Is this the correct part?