Joseph 5 July 10, 2019 for Model Number GI15NDXXS2 My ice maker recently stopped making ice. I think the refrigerant level is low. Can the refrigerant be recharged? Is there a recharging port on the condenser coil? Can I add a recharging port if it does not have one.
1 Answer Hello Joseph, if water is flowing over the evaporator tray, the compressor and condenser fan motor are running but there is no ice slab being formed then it is likely there is a sealed system problem. Sealed system repairs would require an appliance service technician, this is in part due to the tools and equipment needed as well as EPA regulations. Read More...
Calvin September 17, 2013 for Model Number zdic150wwwa Will condencer 2313624 fit zdic150wwwa ? It has a lot of whirpool electrical pieces in it.
1 Answer Hello Calvin. No, not according to the manufacture. You will need to order part number WR84X10081. Read More...
1 Answer Hello Jeff. If you look on the model number tag, it will have the charges and pressures listed on the tag. Read More...
Jeff 1 August 22, 2012 for Model Number ZDI15CBBN So If the condenser is cool - Do I have a freon leak or a bad condensor ? What type of freon is used in this unit ?
1 Answer Hello Jeff. Without checking the pressures and checking the unit with the proper tools there is no way of knowing the problem. You need an HVAC tech to determine the issue with the proper tools. Read More...
Jeff 1 August 22, 2012 for Model Number ZDI15CBBN Response to previous question - "Condensor should be hot to touch as the filter dryer" The condensor is cool - Do you think filter dryer is clogged
1 Answer Hello Jeffw. No, the condenser would be hot and the drier would be cold if the drier was bad. Read More...
Jeff 3 August 21, 2012 for Model Number ZDI15CBBN My ice maker seems to be running just fine everything cycles properly - howeve ice does not form on the freezing plate. what is the proper function of condensor hot or cool to touch
1 Answer Hello Jeff. The condenser should feel hot to the touch, as the filter drier on the unit. Read More...
Michelle May 30, 2012 for Model Number KUIC15NRTS0 My ice maker is making thin patchy ice. I have recently replaced the grid (because a wire was broken) and the circulation pump (2313702) and the thermistor. None of this seemed to fix the problem. The tray is full of water and there is plenty of water running over the plate. What is released to the grid is thin and patchy and there is barely an inch of "ice" in the bin. I am not sure if there is a sealed system leak or if it is cycling too soon or if the plate is not cooling adequately to freeze the water to the desired thickness. Please advise. Thank you.
1 Answer Hello Michelle. Try running some ice machine cleaner WX08X42870 through the system. If the problem continues, and the coils under the bottom are clean and the fan motor is running, you may have a sealed system issue. Read More...