Karen March 08, 2017 for Model Number DU920PFGB3 I need to replace the console on my dishwasher, part # 8051702. The part is discontinued, so I wondered if there is a substitute part that will work.
1 Answer Hello Karen. Sorry, the part needed 8051702 has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Read More...
Bob June 05, 2013 for Model Number DP920PFGQ3 Similar to previous question. Only Low energy and heavy buttons work. Air dry button has no effect. low energy and heavy setting allows washer to operate normally without any problems.
1 Answer Hello Bob. It sounds like the console WP8051702 is bad and will need to be replaced on the unit. Read More...
Gary January 27, 2012 for Model Number DU920PFGB0 The normal wash button no longer works. All others do. Wasting a lot of energy washing on heavy daily. Do I need to replace the whole panel?
1 Answer Hello Gary. Yes, you will need to replace the complete console WP8051702 in the unit to repair the normal button. Hope this helps. Read More...
Bob December 20, 2011 for Model Number DU920PFGZ3 None of the lights on the cycle selection panel illuminate when that cycle is selected, including "Delay Hours". Washing seems to work only for "Pots-N-Pans" cycle. Thermal fuse removed from the electronic control measures 0.1 Ohms with digital Fluke meter. Pressed "HI TEMP WASH, AIR DRY, HI TEMP WASH, AIR DRY" to turn on rapid advance feature. Then repetitively pressed "Pots-N-Pans" to manually advance through the cylce. All cycle steps seem to work. Only the "Washing" & "Clean" status indicators lights illuminated. How do I determine if the electronic control and/or user interface on the console or something else is malfunctioning?
1 Answer Hello Bob. Based on the information you provided, the console WP8051702 is bad on the unit and needs to be replaced. If it were the board, the unit would not rapid advance. Hope this helps. Read More...
Jb December 05, 2011 for Model Number DU920PFGQ4 Dishwasher does not run through whole cycle, stops and 2,4 delay clcle blinks push to start up again and we have to wait before it will begin again. Will not drain unless I cancel operation is it the console?
1 Answer Hello JB. Based on the information you provided, it sounds like the console WP8051702 is bad and will need to be replaced. Hope this helps. Read More...
Charles F. November 24, 2011 for Model Number DU920PFGB2 Controls stay locked and will not unlock holding air dry button or powering off for 20 minutes. I believe the control board is shot. Should I order part number AP3044891? It appears that this contains a new processing board. Thanks.
1 Answer Hi Charles. If the controls/ console commands do not respond then You will need to replace the keypad part # WP8051702. Thank You. Read More...
Kristin June 28, 2011 for Model Number 8052029 rel Dishwasher works fine, but stays on drain cycle and we have to open the door to stop it. Any suggestions?
1 Answer Hello Kristin. We will need your model number to help you with this. Here is a link to our model number locator. Hope this helps. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Kristin June 27, 2011 for Model Number Whirlpool series980 Dishwasher works fine but won't shut off. It stays on the drain cycle until I open the door. Any suggestions?
1 Answer Hello Kristin. Can you provide the model number for the dishwasher? Thanks. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...