Henry Giordanelli August 20, 2020 for Model Number DU930PWSS1 The Dishwasher is connected to energy. No lights come on. How do I reset?
1 Answer Henry G,Based on the information provided the machine would need to be tested with a multi-meter to determine if the incoming power is making it to the control board. It could have a bad door switch or a bad thermal fuse keeping the power from reaching the board. Read More...
Sue January 19, 2015 for Model Number Whirlpool DU930PWSBO Re: Part #W10101930 - The plastic overlay wore out and cracked over my Start button. A perfect black plastic piece broke off. Is replacing this part the only way to replace the overlay? Can the overlay be bought and replaced separately?
1 Answer Hello Sue! Unfortunately, you would have to replace the control panel WPW10101930. Sorry! Read More...
David W June 16, 2014 for Model Number DU9309WSS0 Please provide removal and installation information for this part.
1 Answer David, To remove the control panel you will open the dishwasher door and remove the screws at the top and first couple down the side. The control panel should come off. Once off you will disconnect the wiring and remove the components of panel and install on the new panel and reinstall. Read More...
1 Answer Hello David. You will need to order and replace the control panel WPW10101930 on the unit. Read More...
Joyce P. March 26, 2013 for Model Number du930pwpt2 Dishwasher won't start. Wash cycles lite up but start button won't engage. What can I do?
1 Answer Hello Joyce. If the door switches are good, then you will need to replace the control panel on the unit. Read More...
Cletus P. November 12, 2012 for Model Number 665.13593K600 &790.9535803 I have a Kenmore Dishwasher that will not start, the lights light up but will not start. What could it be? I also have a Kenmore Range, the hot cap light will not go off. What could it be?
1 Answer Hi. Remove the kick panel and or the inner door panel to access the Field tech sheet. Put the unit into a Field service test so it will test each component itself and bring up any fault codes. Use a volt/ohm meter part # MA-DM1 to assist you in your diagnostics. Then test from the control board the wire connections and the component resistance values. Make sure all connections are clean and tight. Make sure the motor wiring is clean and tight. As far as the range - I will need a model # to assist you further. Thank You. Read More...