Jason February 25, 2016 I have a KitchenAide dishwasher model KUDP02FRSS1. Water was not heating and cycle did not dry either. I checked the electronic circuit board and changed it. Works well now but the heavy duty cycle and the 4 hour delay buttons on the control panel are not working. Help me out please. Thanks.
1 Answer Jason, The most likely cause for the heavy cycle and 4 hour delay button to not work would be a faulty control panel but you will want to make sure that the ribbon harness between the control panel and board are seated properly. If it is not then the issue will be a faulty control panel WP8572497. Read More...
Tim September 29, 2015 for Model Number KUDP02FRSS0 Dishwasher was staying in wash cycle and not advancing, I replaced the control board AP4309110 and latch switch. The dishwasher has ran good for about a month now. It is beginning to do the same as before, staying in the wash cycle forever and not advancing thru the cycles. It began to do this intermit ten and now it does it all the time. What else might it be or could this board have a problem, I bought the board from this company and it is barely over 30 days in use. Any suggestions or could there be something else to check.
1 Answer Tim, You would want to check the thermostat if the unit is washing for overly long periods but most likely will be the optical water sensor [APAP5955034]. Read More...
Freddie September 02, 2012 for Model Number KUDP02FRBL0 The Heavy Duty Wash, 4 Hour Delay and Cancel lights on our KitchenAid dishwasher are the only lights on and they are constantly on, even when the dishwasher door is open. I tested the thermal fuse and that is fine. I'm not sure if it is the Panel-cntl (AP3873891), the Electronic Control Board (AP4309110) or something else. Any thoughts? Thanks
1 Answer Hello Freddie, The control panel WP8572497 has stuck buttons. The buttons that the indicator lights are remaining on for are the buttons that are stuck. This is the way the unit is designed to indicate a stuck button is occurring and how you determine which buttons are sticking. Read More...