Mike December 14, 2017 for Model Number WED660VW0 Does this console include the green board and the wire component that connects from this console to the main board that is behind this console? Aso, is it easy to disconnect the old wiring to the main board and connect the new one from this console? Thanks
1 Answer Hello Mike, This console WPW10146153 comes with the display board and the harness that connects it to the control board. Read More...
Dave February 26, 2014 for Model Number wed6600vwo The gray plastic piece that holds the start button in place in the console has broken so that the start button is non-functioning. Do I have to replace the entire console to fix that?
1 Answer Hello Dave. Yes the panel and buttons are only sold as an assembly. Part# WPW10146153 is the correct panel for model. Read More...
Michelle C September 02, 2013 for Model Number Whirlpool Carbio dryer HE Dryer will not heat up; all fuse have been checked and replaced. heating element replaced as well. drum will turn, but not heat.
1 Answer Michelle, you didn't mention a model number or type dryer. If the dryer is an "electric" dryer, you need to make sure you have 220-240 VAC to the dryer. You may also have to check the heater relay on the machine control board, inside the cabinet. The relay has to close in order to send power to the element or gas valve. If you need more assistance, please repost your question and include a model number from the serial plate on the dryer. Thanks Read More...
Terry A. December 21, 2011 for Model Number WED6600VW0 Heat element stays on. Even on air dry setting.
1 Answer Hello Terry. The element 279838 will need to be checked and see if the unit is grounded to metal. If so, it will stay on and does not shut off properly, and will need to be replaced. Hope this helps. Read More...
Ron G. March 02, 2011 Can the start button on the dryer be replaced by itself? Also, what would cause the dryer not to start when the start button is pushed?
1 Answer Ron, the electronic control WPW10051165 is available separate from the console assembly WPW10146153. You will have to order one of the two parts to get the start button. Make sure that the door is closing and latching all the way, this will stop the unit from starting as it should. Also make sure it is getting the correct voltage. Hope this helps! Read More...