Dave March 03, 2018 for Model Number JJW9827DDW We had a power failure the other day and now the oven screen is totally blank and won't work. We've recycled the breaker at the electrical panel and still nothing.
1 Answer Hello Dave. Test L1 and make sure you have power coming to the terminal. If so, and there is power to the board, you will need to replace the control WPW10169130 on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Thank you. Read More...
Dean-O July 30, 2016 for Model Number JJW9830DDS WPW10169130. How do you remove the initial screen,see below, upon power up? MASTER 3--00 SLAVE 4--00 EE DBL CNV P1A2 All controls work, but the above read out flashes on between menu items, really annoying.
1 Answer Dean, You may want to try to put the unit into a test mode to see if there are any stored error codes and see if it will clear this message that is popping up. The test information is located on the tech sheet located in the control panel of the unit. Read More...
Dwayne January 17, 2016 for Model Number JJW9830DDS This oven will not turn on intermittently. if it is unplugged and plug back in, it works normally. What could be the problem ? is the electronic control board going out ?
1 Answer Hello Dwayne. It sounds like the control board WPW10169130 is bad and will need to be replaced on the unit. Read More...
John March 11, 2014 for Model Number jjw9827ddb My oven does not light up. The power went off a few times and when it came back on the next day the oven quit working. It has no lights working on it.
1 Answer Hello John, If you have checked at the terminal block and you have the 240Vac, the control WPW10169130 is the most likely cause of this issue. Read More...
Dale November 26, 2012 for Model Number jjw 9830 dds Both top and bottom burners went out this morning after a pop noise plus both broilers. everything else seems to work including the fan for convection. But of course nothing heats up. Do you think it is the control panel? Everything that needs 240v does not work but it is getting power. Clock and touch pad work fine.
1 Answer Dale, It sounds like you've lost the L2 power supply to the control board WPW10169130. Since it's both ovens, it's not likely a hi limit switch, but could be a damaged wire. The control would be a good place to start, but we'd prefer you test for voltage into and out of the control board with a multi meter, first. Read More...